User manual LIFT-MASTER WOMODKT

[. . . ] Wiegand Module for EL models · Model WOMODKT J405 J500 H2 100A UD J201 MIC D300 H2 100A UD J403 J406 LCD Caution! [. . . ] 3 All wires MUST go through the conduit hole in the back mounting plate of unit. Connect the shield wire from the device(s) to the backplate or earth ground rod. Insulate this wire from the unit to prevent a short (refer to instructions supplied with the Wiegand device for more information). When using an Essex keypad (Chamberlain model # ESSWOKSG), do not connect the brown LED control wire. 4 After the installation is complete, each device connected to the Wiegand Module(s) must be tested by swiping a card or entering a digit once, so that the new module is automatically detected. You can then go into programming and assign your devices to the doors. Callouts Under Connector J405 J500 J406 LCD Device 2 or 4 +12V +5V DATA 0 DATA 1 LED COM J2 J1 J2 J1 J2 J1 3D2 100 16B 3D2 100 16B 100A 3D2 100 16B BT300 SW300 J402 LEDJ200 SPKR 114A2970C © 2006 The Chamberlain Group, Inc. [. . . ] Supporting up to 4 Wiegand devices. J407 Position Device 4 D300 J400 Position Device 1 H2 100A UD Device 3 Device 2 H2 100A UD J403 D2 ® TM [. . . ]