User manual LIFT-MASTER TX2225

[. . . ] ATTENTION - Risk of personal or property damage ATTENTION - Danger due to electrical power or voltage 2. Please read before installation Constructing, checking, starting-up and troubleshooting must only be carried out by a certified electrician (i. Proper operation is only ensured by means of professional installation and sufficient power supply. [. . . ] It will then be the turn of the minute digits; set the desired value and confirm using the STOP (MODE) button; in place of the arrow pointing upwards, an arrow pointing downwards will appear: repeat the abovementioned procedure to programme the desired DOWN command time for Mondays. Once the final confirmation has been given using the STOP (MODE) button, the number 2 (Tuesday) will appear at the bottom of the display with the upward-pointing arrow near the P, while the time digits flash: repeat the abovementioned steps to programme Tuesday's automatic command schedule, and then the schedule for the other days of the week. While setting the hours and minutes, you can scroll through the values more quickly if you press and hold the UP or DOWN buttons: the figures will be increased or decreased respectively in steps of 5. You may exit the programming mode at any time by pressing and holding the STOP (MODE) button for at least 2 seconds. Automatic operation: After this operating mode is selected, the timer sends UP and DOWN commands at the specified times, every single day of the week. it is still possible to submit manual commands in this mode (see paragraph "Manual operation"). Manual operation: In this operating mode, it is possible to submit UP, STOP and DOWN commands simply by pressing the corresponding buttons (UP, STOP (MODE) and DOWN) in accordance with the following logic: if an Up or Down command has already been transmitted to the control unit on which the Timer codes have already been stored (see paragraph "Programming codes on a control unit") and the control unit motor time has not yet elapsed, any further Up, Stop or Down command will cause the motor to stop running. Holiday mode: In this operating mode, the scheduled daily automatic UP or DOWN commands are transmitted at a random period of 1 to 31 minutes before the set times. PROGRAMMING THE TX2225 TO THE CHAMBERLAIN RADIO CONTROLLED TUBULAR MOTOR RANGE To store the timer codes in the memory of electronic control units for sun blinds and rolling shutters, the control unit itself must be programmed accordingly: enter the radio control programming procedure (see relevant instruction manual) and press the UP button on the timer. When the control unit confirms that the procedure has been completed successfully, press any button on the timer: all three buttons (UP, STOP and DOWN) will now have been automatically stored in the memory of the control unit. Press any button of the TX2225 (stay within radio range of drive) · Re-connect power supply and wait · If it has worked, the drive turns 2x briefly as a signal that the command has been understood. The drive turns 2x briefly as a signal indicating that the command has been understood (approx. ⷠThen press the UP button (upper button) and also the DOWN button (lower button) immediately and briefly. Once again the drive moves 2x briefly as a signal that the command has been understood. [. . . ] Defective parts will be repaired or replaced with new or factory rebuilt parts at Chamberlain's option. If, during the warranty period, the product appears as though it may be defective, contact your original place of purchase. This warranty does not affect the purchaser's statutory rights under applicable national legislation in force nor the purchaser's rights against the retailer arising from their sales/purchase contract. [. . . ]