User manual LG VC9025FM

[. . . ] All safety messages will follow the safety alert symbol and either the word "WARNING" or "CAUTION. This symbol will alert you to hazards or unsafe practices which could cause serious bodily harm or death. This symbol will alert you to hazards or unsafe practices which could cause bodily injury or property damage. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] If suction power decrease after cleaning dust tank, clean air filter and motor safety filter. Make sure the filters (motor safety filter and air filter) are completely dry before replacing in the machine. If the power cord is damaged, it must be replaced by an approved LG Electronics Service Agent to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Do not approach to vacuum cleaner suddenly, when FOLLOW ME function activated. This vacuum cleaner has a special thermostat that protects the vacuum cleaner in case of motor overheating. If the vacuum cleaner suddenly shuts off, turn off the switch and unplug the vacuum cleaner. Check the vacuum cleaner for possible source of overheating such as a full dust tank, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch. If the vacuum cleaner still does not run, contact a qualified electrician. Connecting the hose to the vacuum cleaner Raccordement du flexible à l'aspirateur Push the fitting pipe on the flexible hose into the attachment point on the vacuum cleaner. To remove the flexible hose from the vacuum cleaner, press the button situated on the fitting pipe, then pull the fitting pipe out of the vacuum cleaner. Pull out the power cord to the desired length and plug into the socket. Use vacuum cleaner body control Knob to adjust suction power MAX To turn off, press the power button again. When alarm sounds: Power is on without dust tank or dust tank is not installed clearly. Press the Power Button E ven if the control Knob located on the "min", vacuum cleaner work instantly. When parking temporarily or storing cleaner, you should FM ON/OFF switch to OFF position or unplug the cord. To store during vacuuming, for example to move a small piece of furniture or a rug, use park mode to support the flexible hose and nozzle. - Slide the hook on the nozzle into the slot on the side of vacuum cleaner. When you have switched off and unplugged the vacuum cleaner, press the cord reel button to automatically rewind the cord. [. . . ] If suction power decreases after cleaning the dust tank, clean the air filter and the motor safety filter . The air filter and the motor safety filter are located on the top of the vacuum cleaner as above the figure. Open the guide cover by pulling the guide cover lever and remove the dust. Open the air filter cover by pushing the air filter cover lever and take out the air filter. [. . . ]