User manual LG CH12NS30

[. . . ] • This BD-ROM/DVD Writer is for use only with UL listed personal computers that have installation instructions detailing user-installation of card cage accessory. i EU Conformity Notice LG Electronics hereby declares that this/these product(s) is/are in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC, 2006/95/EC, and 2009/125/EC. - EU Representative Krijgsman 1, 1186 DM Amstelveen The Netherlands CAUTION : CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. ADVARSEL : KLASSE 3B SYNLIG OG USYNLIG LASERSTRÅLING VED ÅBNING. [. . . ] Note that most monitors and graphics cards currently don’t support HDCP. But, most High Definition TVs and multimedia monitors do support HDCP. Refer to the PC or graphic card maker’s web site to see if your card supports HDCP. Some video cards that currently support HDCP: - Blu-ray Disc playback: Intel G45, ATA radeon HD 2400, nVdia GeForce 7600GT or above. - 3D playback: Intel G45, ATA radeon HD2400, nVdia GeForce 8800GT or above. *1 *2 Graphic card driver shall meet AACS compliance criteria. HDCP (High Bandwidth Digital Content Protection): Required to view pre-recoded Blu-ray Disc which are copy protected. 3 ❏ Occasionally CD-R and CD-RW discs written by a CD-R/RW drive cannot be read by other CD drives. These unreadable discs may need to be read using the CD-R/RW drive they were created with. particularly those including Video playback) may require a considerably increased specification PC to give acceptable results. While this BD-ROM/DVD Rewriter can read DVD-video or BD-MV(BD-ROM) discs, decoding them to display on your pc’s monitor requires separate MPEG, H. 264 or VC-1 decoding that is done by separate hardware (either an MPEG, H. 264 or VC-1 decoder card or MPEG, H. 264 or VC-1 decoding done by your video card), or separate software that you install to do MPEG, H. 264 or VC-1 decoding. For further details, refer to the documentation that comes with MPEG, H. 264 or VC-1 software. Location and Function of Controls Front Panel Rear Panel 1 2 3 4 1 2 1. Drive activity indicators The LED is used to indicate the operation of BD-ROM/DVD Writer. 1. Eject Button 4 Installing the Drive Before installing the drive, please note the following points. ■ You will need the following: • A screw driver of a suitable size to fit the securing screws for the drive unit. • The manual for the computer, so you can find the mounting positions for the SATA cable. ■ Turn off all peripheral appliances of the computer and the computer itself, and disconnect their power cords from the wall sockets. ■ Discharge any static electricity on your person by touching the computer covers, etc. Removing the Computer Cover Make sure all peripheral devices of the computer and the computer itself are turned off, and then remove the cover. Refer to the manual for the computer for details about removing the cover. NOTE : There may be sharp edges inside the computer so take care to avoid injury. Mounting the Drive 1. [. . . ] It is an extremely rare occurrence, but there are steps which can be taken to prevent it. Take care not to use worn, cracked, damaged, warped or poor quality discs, as this may cause damage to your drive. Check the clear plastic on the center of the disc, cracks here are the main cause of disc crush. [. . . ]