User manual LEXMARK T622

[. . . ] Use, duplication or disclosure by the Government is subject to restrictions as set forth in subparagraph (c)(1)(ii) of the Rights in Technical Data and Computer Software clause at DFARS 252. The 2000-sheet drawer gives your printer added capacity by allowing you to load up to four reams (approximately 2, 000 sheets) of 20 lb paper. Your printer has an autoconnect feature that recognizes when the 2000-sheet drawer has been installed. After starting your printer, this option is shown as Tray 2, Tray 3, Tray 4 or Tray 5, depending upon the number of installed paper sources. [. . . ] Openings on top of the drawer will help you set the printer so the edges are aligned properly. 8 If you intend to operate your 2000-sheet drawer at 100 - 127V power, you Must use the 16 AWG power cord provided with the unit. Plug the 16 AWG power cord into the back of the drawer and then into a properly grounded electrical outlet. Do not use the power cord provided with the printer; however, you may retain it for possible future use. For example, if you later decide to detach the current printer from the 2000-sheet drawer, and use the printer with other paper options, you should use the original power cord provided with the printer. The 16 AWg power cord should always remain with the 2000-sheet drawer. If you intend to operate your 2000-sheet drawer at 200 240V power, use the power cord provided with the printer. Plug the power cord into the back of the drawer and then into a properly grounded electrical outlet. 1 Make sure the printer power is on and the Ready status message appears 3 Continue to press and release Menu until Utilities Menu appears on the Utilities Menu now appears on the first line of the display. 5 Press and release Menu until Print Menus appears on the second line of If the drawer is listed, you are ready to begin using it. If the drawer is not listed on the page, the printer or other options may not be seated securely or aligned properly. Return to page 6 of this guide and carefully follow all installation instructions. To set the paper type, go to the printer operator panel, and then follow these steps: 1 Make sure the printer power is on and the Ready status message appears 3 Continue to press and release Menu until Paper Menu appears on the 5 Continue to press and release Menu until Paper Type appears on the 7 Continue to press and release Menu until Tray x Type (where x represents 9 Continue to press and release Menu until the paper type you are using in Note: You may select any operator panel feature available except Paper Type = Transparency. Your 2000-sheet drawer comes pre-configured for either letter or A4 paper size. To change the paper size prior to installation, proceed to step 7 of the following instructions now. If you are changing the paper size for a unit that is already attached to a printer and a power source, proceed with step 1: 2 Push the elevator down button located on the left side of the door opening. Make sure your fingers are not under the printer when you set it down. A new paper size is displayed on the operator panel after the paper elevator tray is in the up position. 8 To make a selection, turn the knob completely in a counterclockwise direction. 9 Count the clicks as you turn the knob clockwise to find the correct paper size. Note: Make a note of the color associated with the paper size you select. 10 Pull each locking pin up to unlock it, and then pull up on the guides to The unit, corresponding to the paper size you selected. [. . . ] The power cord is plugged firmly into the back of the 2000-sheet drawer. Remove the paper in the printer paper path and check the paper stack to ensure the paper has been loaded properly. Be sure to remove the top and bottom sheets of each ream of paper that is loaded. The power cord is plugged firmly into the back of the 2000-sheet drawer. [. . . ]