User manual LEXMARK 2300 Install Guide

[. . . ] Changes are periodically made to the information herein; these changes will be incorporated in later editions. Improvements or changes in the products or the programs described may be made at any time. Lexmark may use or distribute any of the information you supply in any way it believes appropriate without incurring any obligation to you. You can purchase additional copies of publications related to this product by calling 1-800-553-9727. [. . . ] 1 Type the IP address of the OptraImage in the URL field of Your browser, and then press Enter. Before you create a destination, check the list at the bottom of the Web page. 8 If you want, assign a shortcut number (1- 245) to the You can rapidly find your FTP recipient by pressing # and entering the shortcut number on the OptraImage control panel. This new destination is now available for Make a test copy 3 Press Go/Send to send a copy to your printer. Remember you can only test the scan to network functions that you configured during setup. For example, to test Scan to e-mail, you must have created at least one permanent e-mail destination. Otherwise, SCAN EMAIL does not appear as a scan to network mode in the OptraImage control panel. OptraImage online documentation includes helpful instructions for making copies, sending faxes, and scanning documents to e-mail, FTP destinations, or back to your computer. To view the available information on the OptraImage CD, click View Documentation, and then Use OptraImage to browse the table of contents. Here are several ways to distribute OptraImage information: · Print copies of each set of user instructions stored on the OptraImage CD, and manually deliver them to users. Copy the PDFs containing the user instructions and store them in a convenient common location on your network or Intranet. The manufacturer is not responsible for any radio or television interference caused by using other than recommended cables or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to operate this equipment. On the backside of this option card is a label that contains, among other information, the FCC registration number and Ringer Equivalence Number (REN) for this equipment. If requested, this information must be provided to the Telephone Company. The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the device not ringing in response to an incoming call. In most, but not all, areas the sum of the RENs should not exceed five (5. To be certain of the number of devices that may be connected to the line as determined by the REN, contact the telephone company to determine the maximum REN for the calling area. This equipment cannot be used on telephone company-provided coin service. This equipment uses the following Universal Service Order Code (USOC) jack: RJ-11C. This equipment is designed to be connected to the telephone network or premises wiring using a compatible jack which is FCC Part 68 compliant. [. . . ] If a charge for local calls is unacceptable, the "Dial" button should NOT be used for local calls. Only the 7-digits of the local number should be dialed from your telephone. No `111' or other calls can be made from this device during a main power failure. This modem must be used in conjunction with an approved surge protection device when connected to the PSTN network. [. . . ]