User manual LEXICON 960L V2.40 INSTALLATION AND RELEASE NOTES REV 2

[. . . ] assumes no responsibility for errors that may appear within this document. 2 960L Version 2. 40 Software Upgrade Installation Instructions & Release Notes WARNING These service instructions are for use by qualified personnel only. Do not perform any servicing other than that contained in these instructions unless qualified to do so. Refer to safety summary prior to performing any service. 3 Installation Instructions & Release Notes Lexicon This document contains installation instructions for the 960L Version 2. 40 Software. [. . . ] Please remove CD from drive. 4 960L Version 2. 40 Software Installation Instructions & Release Notes 3. If the LARC2 requires an update, the LARC2 will display the following menu: Update needed on Larc2: Press '1' to update Press '0' to ignore 4. After the LARC2 update is complete, the following message will appear: Please enter serial number of the 960L from the back panel of the 960L chassis. Do not enter first letter (shown as x ) Use minus for - : Use left arrow < for backspace : Finish with ENTER. x_ Note: When reinstalling Version 2. 40, the unit will not ask to have the serial number reentered if this process was completed during a previous installation. Enter the serial number as it appears on the back panel of the 960L mainframe. The following message will appear: Please re-enter serial number for verification . Enter the serial number again as it appears on the back panel of the 960L mainframe. After the system has started, verify that the software has been installed properly. To do this, press the CONTROL button, then the SYSTEM button, and read the version information on the screen. Once this process is complete, configure the system and continue working. It is recommended to read the 960L Owner's Manual to make the most of the 960L. 5 Installation Instructions & Release Notes REVERTING TO A PREVIOUS SOFTWARE VERSION Lexicon To revert to a previous version of 960L software, follow the same procedure outlined above using the release CD for the desired software version. There is one special consideration: When upgrading to Version 2. 40, the software recognizes prior versions of user registers and automatically converts them to a compatible format. Therefore, when performing a "back-rev, " erase all user registers before inserting the release CD. It is recommended to save them first, noting the software version of the user registers. As soon as the LARC2 receives power, go to Menu Mode by pressing and holding the PROGRAM and MACHINE keys at the same time. Hold them until the following message appears: Requesting menu mode from 960L . [. . . ] Occasionally, LARC2 motorized faders may exhibit a "vibrating" characteristic when settling into a new position as programs are loaded. This characteristic may appear to be inconsistent from fader to fader. This is normal due to the varying characteristics of individual fader components. [. . . ]