User manual LEXICON 200

[. . . ] the cores in the mains lead are coloured in accordance with the following code: GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live As colours of the cores in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: the core which is coloured green and yellow must be connected to the terminal in the plug marked with the letter e, or with the earth symbol, or coloured green, or green and yellow. · the core which is coloured blue must be connected to the terminal marked N or coloured black. · the core which is coloured brown must be connected to the terminal marked L or coloured red. · UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] With DHCP enabled, the Ethernet switch/router should assign an IP address to each of the devices including your computer. The 200 units should come up in the main window. 20 vIRtUAL PRIvAte NetWoRKS (vPN) Virtual private networks (VPN) provide an encrypted connection (or tunnel) between networks or between a network and a user over a public network (such as the Internet). Instead of using a dedicated, real-world connection such as a leased line, a VPN uses virtual connections through the public network. The advantage to a VPN is that your computer can be virtually connected to a local network even though it is physically anywhere in the world where you have an internet connection. This can also be done in a safe manner not compromising your local network's security. If you would like to manage your 200 units remotely you should create a secure VPN connection. These products offer different features, methods of VPN, complexity of setup and maintenance, as well as varying levels of security. It is beyond the scope of this manual to recommend a VPN solution that will best suit the needs of your network, although you will need a VPN that is capable of passing UDP and TCP traffic (most do). The 200 has been tested against several solutions and should work with all VPNs that meet these criteria. Please work with your system administrator and Internet service provider to find a VPN that will best fit your network. The 3Com OfficeConnect Secure Router (model # 3CR860-95) is one solution that has been tested, and is both inexpensive and simple to set up. "Invalid" indicates that the Validity bit was set in a frame of incoming data and that the data attached to it may be corrupted. This bit may also be sent when the 23 transmitting device is paused. Mode - Select "Consumer" to send information in S/PDIF format. "1" indicates the 200 is detecting excessive jitter or noise on the digital audio line. Sample Slip - An unchanging number indicates you are not slipping samples. An increasing number indicates samples are misaligned with the window defined by the Input Source. This may occur when an external master changes sample rate, or when it is just powering up, but should not occur in normal operation. "1" indicates that at least one bit (and therefore at least one audio sample) was corrupted. "1" indicates a Cyclic Redundancy Check error in the incoming data. "1" indicates that at least one bit (and therefore at least one audio sample) was corrupted. MAchINe coNFIG The Machine Config menu lets you configure the 200 processor as one, two, three, or four virtual machines in a new preset. Note that once you've selected a configuration, you must then populate each virtual machine with a Machine Preset (see page 11 for more information). [. . . ] This only has an effect when the signal type is set to sweep tones or pink click. Signal Frequency Changes the frequency of the signal generator sine wave. This only has an effect when the signal type is set to sine wave. 44 Signal Type Selects the type of signal to be created by the signal generator. The types of signal are: · · · · · · · · Sine Wave -- When this is selected the signal frequency parameter is used to control frequency. [. . . ]