User manual LEXIBOOK TW40Z

[. . . ] Technical specification Operating frequency 446. 00625 to 446. 09375 MHz (eight channels) Channel spacing 12. 5 KHz Output power 0. 5 W Kind of product: Type number: Walkie-Talkie with charger TW40Z User Guide MENU button Press to change channels and sub-channels and to switch between modes Press the PTT button to confirm the setting. to which this declaration relates, is in conformity with the following standards and/or other normative documents. ETSI EN300 296-2: 2001 EN301489: 2002 EN60065: 1998 We hereby declare that the above named product is in conformity to all the essential requirements of Directive 1999/5/EC. Denis Mauduit Quality Manager The display switches backwards and forwards between the two channels. If the handset detects a signal on either channel, it will stop and receive it. [. . . ] Using the Personal Mobile Radio (PMR) Volume control Monitoring the current channel Normally Your PMR will not pick up very weak signais. To activate the monitoring feature Press the MENU and buttons at the same time. Press the or button to change the Call-Ring tone. (5 different tones), the different Call-Ring tone can be heard during changing. Transmitting range The talk range depends on environmental and terrain. It will be greatest (up to about 3km or 1 3/4 miles) in wide open spaces, without obstructions such as hills or buildings. Don't try to use two PMR handsets which are less than 1. 5m (5 feet) apart. PMR446 is an open-license band - always identify yourself when transmitting, as other people may be communicating on the same channel. To adjust the loudspeaker volume. You can change the volume either While you're using your PMR handset, or while the handset is idle (switched on but not in Use). Press the PTT button to confirm your setting after you select your desired Call-Tone. Setting Call-Ring off When you send a Cali Ring you also hear it on your handset. If you do not want to hear it, follow the procedure below. Your handset will pick up any signals on the current channel, including background noise. Changing the channels and sub-channels Your PMR has eight channels, numbered 1 to 8. To communicate with other PMR users within range, you must ali have your PMR tuned to the same channel. Then switch on the main socket. Effective Range The Transmission range of the product is wholly dependent on the environment or terrain in which it is being used, the following diagram attempts to guide the user on the sort of performance to expect in everyday use. Press the MENU button 4 times, the unit enters Call-Ring setting mode. VOX (voice activated transmission) mode In VOX mode your PMR will transmit whenever it detects your Voice (or other noise) without the PTT button having to be pressed. At the highest level (level 3) , the handset will pickup softer noise (including background noise); at the lowest level, it will pick up only quite loud noise. Plug the handsfree kit's socket into Mic/Spk jack. Press the or buttons until you see on the display. 1. DO NOT REMOVE THE SLEEVE FROM THE BATTERY PACK. Press the PTT button to confirm your setting. To remove the belt clip It is easier to fit the batteries without the belt clip in place. Pull the tab forward (away from the handset) to release the belt clip. Then lift the belt clip off. The PMR must be charged using the mains adaptor provided. Using any other adaptor will result in non-compliance with En6OO65 and will invalidate any approval/warranty for this product. Signal Strength Optimum (open area) (1) Press the PTT button to confirm the channel setting. Each channel also has 38 sub-channels (Sometimes called CTCSS Codes) let ting you set up groups of users within the same channels, for more private communication. If you have set sub-channel, you can communicate only with other users tuned to the same channel and sub-channel. To turn the sub-channel function off, simply set the sub-channel to 0 (zero). Then you can communicate with any PMR user on the same channel who also turned off sub-channel operation(or whose PMR does not have the feature). Roger Beep ON/OFF setting The Roger Beep is a tone which is automatically transmitted whenever the PTT button is released. [. . . ] · To reduce radio frequency exposure when you're using your by TW40Z , hold the handset at least 5cm (2inches) from your face. Dry the battery compartment and leave the battery cover off for a few hours. Make sure the battery compartment cover is securely locked in place when you are charging the battery pack. Disposed of used batteries safely and in a way that will not harm the environment - never try to burn them or put them anywhere, they could get burnt or punctured. [. . . ]