User manual LEXIBOOK ST10

[. . . ] If your device cannot be programmed using manual setup or its code is not in the list, program your remote control using the quick or auto search function. The search function tests all the codes one after another and finds the right one for your device. This search should be used only if Manual search failed or if the brand or correct model code are missing. Press the SET key followed by the respective device key on your remote control. [. . . ] DO NOT press the POWER button again, as this would restart the code search. Return to your device and switch it ON again (by using original remote control or the device's front panel buttons). In order to fine tune the search within these 5 codes, you must press the power key and wait 2 seconds. If nothing happens, repeat by pressing power again and wait 2 seconds. If your device still does not respond, you should only need to press the power key 5 times in total before your device turns back OFF. DO NOT press the POWER button again, as this would re-start the code search. Check whether all applications of your device can be operated using the remote control keys. There is a different code list for each of the 10 devices which your remote control can be set to. You might have to try several of them before finding the one relevant to your model (see hereunder). Press the SET key first and hold it down while pressing the respective device key on your remote control, hold both keys down. For example: To program your TV, press first SET and then TV1 simultaneously. In other words, you will be able to execute several control commands in the order they were stored by simply pressing the respective MACRO key. Press and hold the SET button, then press one of the MACRO keys (M1, M2, and M3). Now press the buttons, the application of which you would like to activate successively in the respective order. For example: You wish to store the following control command sequence on M1: TV1 on ­ Switch to TV/VCR ­ VCR on ­ Play ­ Switch to TV. Then, you have to enter : SET + M1 ­ TV1 ­ POWER ­ TV/VCR ­ VCR ­ POWER ­ PLAY ­ TV1 ­ M1. If more than 15 control commands have been selected or no button was pressed for more than 30 seconds, programming stops automatically, the LED goes off and the last MACRO settings will be stored. The LED lights up; its flashing indicates the first digit of the code. When the back light function is enabled, press any key and the light will turn on for 5 seconds and will remain on when a key is pressed. Always write down the 3-digit code for your remote control after running the search and saving the code. This may be useful if you need to reprogram your remote control in the event of accidental cancellation or when you change used batteries. when searching the code , the LED will flash corresponding to the numerals of the 3-digit code. [. . . ] Problem The brand of your audio-video device is not listed in the code book. Make sure you have pressed the corresponding device key (TV1, TV2, DVD, CD, VCR1, VCR2, SAT, CBL, AMP or AUX). The ST10 Universal Remote Control may not have all the functions of the original remote control of your audio-video device. For all matters relating to the guarantee or our after-sales service, please contact your retailer and have your receipt on hand. [. . . ]