User manual LEXIBOOK SM1300

[. . . ] The MeteoClock SM1300 incorporates different functions: - Thermometer: Temperature is displayed in real time to the nearest tenth of a degree Celsius. Thanks to its wireless sensor, the station can sense from a distance the outside temperature or that of another room!- Hygrometer: Outdoor or indoor hygrometry is expressed in percentage of humidity in the ambient air. [. . . ] Press Hour/+/Max or Minute/-/Min key increments/decrements relative to Clock 1). DATE, YEAR & ALARM SETTING Date Setting: Scroll to date mode using MODE/SNOOZE. February will have either 28 or 29 days depending on the year setting. Alarm 1and Alarm 2 Setting Scroll to Alarm1 mode (Alarm2 mode) using MODE/SNOOZE. When the alarm is set ON, the 'on' symbol will appeart. to change the hour (in one hour 6 Copyright © Lexibook 2004 Copyright © Lexibook 2004 7 SM1300GB 7/8/04 5:30 PM Page 8 When Alarm Sounds 1 or 2 will flash Press MODE/SNOOZE to snooze the alarm for 5 minutes. Without interruption, alarm will shut off automatically after one minute. WEATHER DISPLAY Check Local Temperature (Inside) After insert batteries, local temperature will display. Check Remote Temperature & Humidity Press CHN to toggle between Channel 1, 2 and 3. °C or °F Temperature Display MOON PHASE The moon phase is automatically updated according to the year/month/day. Moon Phase Display: New Moon Young Crescent First Quarter Waxing Gibbous Full Moon Waning Gibbous Last Quarter Old Crescent Toggle between °C and °F by pressing Alarm °C/°F at Clock2 mode. Min and Max Temperature & Humidity Press Minute/-/Min in Clock1 mode to display minimum temperature and humidity. Press Hour/+/MAX in Clock1 mode to display maximum temperature and humidity. Note: Min/Max readings are automatically cleared daily at 00:00. 8 Copyright © Lexibook 2004 Copyright © Lexibook 2004 9 SM1300GB 7/8/04 5:30 PM Page 10 WEATHER DISPLAY Temperature & humidity trend The trend indicator shows the trend of temperature and humidity determined by the particular transmitter in the past half-hour interval. TEMPERATURE ALARM You can set up to 5 high temperature alarms - one local and one for each of the four remote channels. High temperature alarm Scroll to high temperature alarm mode using MODE/SNOOZE. To disable particular alarm, press Alarm°C/°F; dashes = alarm disabled. Repeat steps to for all other channels if desired. Weather report symbols The receiver is able to monitor and display the weather status based on collected data from Channel 1. About Snow Freeze Warning * Snow symbol will flash to warn of 'snowing'. * Activated when Channel 1's temperature is between -1. 9 °C and +2. 9 °C. * Snow will appear solid if and when Channel 1's temperature falls below -1. 9 °C: it is freezing. [. . . ] - Make sure remote transmitter is away from sources of electrical disturbance. 12 Copyright © Lexibook 2004 Copyright © Lexibook 2004 13 SM1300GB 7/8/04 5:30 PM Page 14 ACCESSORIES Additional sensor : Mesure temperature and hygrometry in other places!- upstairs - in the baby's bedroom - in the basement - in the garden - in another room To order: 0808 100 3015 or www. lexibook. com WARRANTY This product is covered by our two-year warranty. To make use of the warranty or the after-sales service, please contact your retailer and supply proof of purchase. [. . . ]