User manual LEXIBOOK RL960

[. . . ] Serenity® Clock is designed to automatically synchronize its calendar clock once it is brought within the reception range of the UK atomic clock MSF signal, for GMT 0 (UK, Ireland, Portugal) 1. Make sure the correct time-zone is selected as described under `Selecting the time-zone and clock display language' on page 18. The clock automatically starts scanning the RCC signal after it is powered on and the Radio Tower symbol starts to blink See (Fig. A complete reception generally takes several minutes, depending on the strength of the radio signal. [. . . ] In clock mode, press and hold for 2 seconds to enter time-zone and language setting mode. Press and hold any button except When the alarm rings: The polyphonic melody will start at the selected alarm time in low volume and will increase within approximately 60 seconds to full volume. If the alarm is not stopped, it will automatically stop after an hour. Select a preset radio station In clock display mode, press until displayed to turn the radio alarm on. When the alarm rings If the alarm is not stopped, it will automatically stop after an hour. You can set the time before the clock repeats the snooze alarm between 5 and 12 minutes (DUR 05 - 12). Wake up gently with the sounds of nature, soothing music and soft light effects. The awakening sequence will start before the set time to wake up the user in a natural way until the set alarm time is reached. ENGLISH There are 3 user-selectable awakening themes: Countryside: sounds of streams, birds, bells, sheep . At the beginning of the awakening sequence the sound will be in low volume and the light dim. During the wake up period the volume will gradually increase and more sounds will be added until the maximum level is reached at the set wake up time. Also, the light intensity is increasing over time to simulate the raising sun and tell the sleeping body that the night is over and a new day is dawning. To enjoy the awakening experience to the most, set the awakening period and volume to your preference. if the alarm is not stopped , it will automatically end at the time set. OR Press to repeat (snooze) the alarm (the whole awakening sequence will be repeated). The slumber mode has been developed with our busy and hectic lifestyle in mind. The same themes as for awakening mode can be selected, and the slumber duration as well as the lightshow on or off can be set. Slowly the volume will decrease and fewer and fewer sounds are played. the light intensity will gradually be reduced to give the impression of a peaceful sunset. As the light is fading and the sounds fade the user is falling into a healthy sleep. If an alarm is set for the next day, the volume should not be set too low as otherwise the sounds might not be heard and the user will oversleep. Enter the slumber theme set mode Press and hold for 2 seconds while in clock mode. [. . . ] - Do not use the product in or close to water or in high moisture locations (the bathroom for example). It should be unplugged during severe storms or when you are away for a long time. Only use the type of power source specified in this instruction manual. Care precautions - To clean the unit, only use a soft cloth moistened with water. [. . . ]