User manual LEXIBOOK RL010DP

[. . . ] Star Light Tuning Control ALARM SET: Set the alarm time TIME SET: Set the clock SLEEP: Set automatic turn off VOLUME Control: Set the volume Display AC cord (rear of unit) Battery compartment (bottom of unit) FUNCTION switch: Set the modes Band switch AM/FM HOUR: Set the hours MIN: Set the minutes Star Light button: Turn the Star Light on/off SNOOZE: Turn off the alarm FM Antenna wire (rear of unit) ABOUT THIS MANUAL Please observe the following safety instructions carefully before putting the unit I into Operation. If you seil or pass on the pro-duct, make sure to include this manual together with the unit. MAKE SURE THAT THE UNIT IS NOT EXPOSED TO: - humidity or moisture; - direct sunlight or other direct heat (e. [. . . ] BACKUP-BATTERY If the mains adapter is pulled from the power socket or there is a power failure this clock runs on two batteries (AAA size). TO INSTALL THE BATTERIES Remove the battery compartment door by inserting a small screwdriver, paper clip or similar item into the tab while gently pushing to remove. Be sure to observe the polarity markings which are engraved inside the battery compartment. - If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. Slide the function switch uto the ON position to turn the unit on; the AM or FM indicator will light. To turn the star light on, press the star light button; the star light will then light from dim to bright repeatedly on the castle top. Backlight: The display`s blacklight will always be on when the unit is plugged in. While holding the TIME SET button , press the HOUR button , to set the hour and/or MIN button , to set the minute of the time. Release the TIME SET button ; after 4 seconds, the alarm time will be set and the display will show the actual time again. NOTE: You cannot set the alarm time when the function switch is set to the OFF position. While holding the ALARM SET button , press the HOUR button , to set the hour and/or MIN button , to set the minute of the alarm time. Release the ALARM SET button ;after 4 seconds, the alarm time will be set and the display will show the actual time again. NOTE: If the volume is set to Minimum, there will be no sound when the alarm time is reached. When the actual time matches the selected preset alarm time, the radio will automatically turn on for nearly one hour then turn off again. [. . . ] NOTE: To cancel sleep timer, slide the function switch to the off position. Do not apply chemical solvents or cleaning agents, as they may damage the surface and/or labelling of the unit. At the end of its life, the appliance must not be disposed of in household rubbish. [. . . ]