User manual LEXIBOOK REMOTE CONTROL RCFOOT

[. . . ] - Release the Velcro fastening on the bottom of the Plush Football and take out the battery compartment from inside, taking care to ensure that you do not pull the battery connector cable too hard and break it. - Unscrew the battery cover and lift it off from the back, to ensure that you do not break the small location lug on the battery compartment lid. - Remove old batteries, if necessary, and insert two (2) new AA batteries. [. . . ] B) Press and hold down both keys "CH+" and "VOL-" for about 2 seconds until the sound "beep_beep_beep" is heard. C) Press and release the "TV" key repeatedly, slowly and patiently until the TV switches off. If no key is pressed within 25 seconds, a "beep" sound will be heard and the URC will resume Normal Operation. D) Press both keys "CH+" and "VOL-" again to lock in the code. NOTE: a) Each time you press the "TV" key, the URC will skip to the next code and transmit a POWER signal to turn off your TV. B) If you fail to stop pressing the "TV" key when your TV has switched off, switch your TV back on again immediately. By doing this you can then use the MUTE key to step backwards through the codes you skipped to re-find the correct code. C) If two "beep_beep" sounds are heard after pressing the "TV" key, that means you have already searched through all the codes contained in the library. Press both keys "CH+" and "VOL-" to exit the Searching Mode and repeat the above procedures carefully to start searching again. Once you have set up your URC, it should work like your original TV remote control. However, certain function keys may not work correctly depending on the DEVICE CODE searched. To operate, simply aim the URC at your TV and then press the relevant button for the function you wish to perform i. NOTE: If certain functions do not operate you may have chosen the wrong DEVICE CODE, even though the TV switched off during the setting up procedure. If this happens repeat the procedures in setting up the URC and try another CODE after the original one you accepted. [. . . ] In case of any fault please return the unit to the address below for replacement or repair. A copy of your sales receipt must be provided, or other proof of purchase. This warranty does not cover damage or faults occurring through misuse, damage or abuse. [. . . ]