User manual LEXIBOOK METEOCLOCK PURE SM1670

[. . . ] It displays the weather forecast by means of animated icons (sun, clouds, rain. Outdoor temperature (°C/°F) and humidity (%), main unit low battery indicator ( ), remote sensor reception channel (1, 2 or3), remote sensor signal ( is displayed briefly during the automatic synchronization of the main unit and the remote sensor) A3. LED (indicates that the main unit and the remote sensor are connected) D2. Use a screwdriver to open the battery compartment located at the back of the remote sensor. [. . . ] Note: it may take up to 1 minute before the main unit displays the readings. However, if the sensor (or the main unit) is too close to other electrical devices, interference may cause malfunction. Use the channel selector located inside the sensor's battery compartment to change the channel. Press and hold the "CHANNEL" key for a few seconds to reset the temperature and humidity readings of the remote sensor. The main unit will resynchronize with the new channel selected for the remote sensor. note: · If the sensor is exposed to very low temperatures for an extended period of time, the batteries may lose power which may cause the transmission range to be limited. If the main unit doesn't receive readings from the remote sensor, "- -. Multiple sensor use The channel function allows you to use up to 3 additional sensors. The main unit can identify each remote sensor thanks to their assigned channel (channel 1, 2 or 3). If you have one or two additional sensors, you can place them in a different location in your house; in a bedroom, for example. Your main unit can collect the temperature and humidity data of up to three remote sensors. Press the TX key inside the remote sensors to synchronize them manually with the main unit. Note: it may take up to 1 minute before the main unit displays the readings. Press the "CHANNEL" key repeatedly to select the desired outdoor channel between the 3 available channels ( ). To display successively the readings from all 3 remote sensors, press the "CHANNEL" key repeatedly until the icon is displayed on screen. Press and hold the "MODE/SET" key until the weather station plays a "beep" sound and the hour's digits start flashing. Use the " /(12-24)" and " /ALARM ON-OFF" keys to increase or reduce the values, then press "MODE/SET" to confirm and adjust the next setting. The setting sequence is displayed in the following order: Hours Minutes Seconds Year Month Date Day-of-week language Country City Time zone 4. Press the "MODE/SET" key to confirm your selection and go back to time display. Use the " /(12-24)" key to toggle between 24hr or 12hr display. You can change this setting when traveling in a city located in a different time zone from yours. The day of the week can be displayed in 8 different languages: English (EN), French (FR), Italian (IT), Spanish (ES), German (GE), Danish (DA), Dutch (NL) or Russian (RU). [. . . ] Press the "SNOOZE/LIGHT" key once to switch on the backlight for a few seconds. Ensure the remote sensor is out of direct sunlight, and away from sources of heat. There may be some interference caused by electrical devices: change the sensor's channel. Make sure the remote sensor is away from sources of electrical disturbance. [. . . ]