User manual LERVIA KH 4435 ROLL CUTTER

[. . . ] This paper trimmer is intended for the cutting and cold lamination of paper in domestic environments. This paper trimmer is not intended for commercial or industrial applications. [. . . ] â· Always place the paper trimmer on a stable and level surface. Q Knob w Cutting rail e Cutting head r Locking device t Covering cap y Lid for the accessory box Paper Trimmer 3 Cutting heads 3 Cold laminate foils Operating Manual Using the cutting head Cutting head can be slid to both ends of the cutting rail). Whilst cutting, firmly hold the paper in position with your left hand. To do this, press the locking device in and then Now open the accessory box and exchange The removed cutting head for its replacement. Place the new cutting head on the cutting rail Bring the covering cap back into position by the cutting rail, press the locking device in and slide the covering cap fully back onto the cutting rail. Press the lid lightly down at the arrow marking and then pull it in the direction of the arrow to unlatch it. Reclose the lid by bringing it back into its lowered position and then pushing it back in until it engages. Open the cold lamination foil and lay the paper With the viewing side down on the non-adhesive foil side (Fig. For this, first crease the protective paper to the rear and then carefully pull off the pre-stamped strip of the protective paper (Fig. Hold the protective paper in the folded-out position and guide the foil envelope into the laminator with the fused end leading (Fig. Turn the knob to the left and continue to hold the protective paper firmly. Contine turning the knob until the foil envelope has passed completely through the laminator. [. . . ] The warranty covers only claims for material and maufacturing defects, not for wearing parts or for damage to fragile components, e. If this product has been subjected to improper or inappropriate handling, abuse, or modifications not carried out by one of our authorised sales and service outlets, the warranty will be considered void. [. . . ]