User manual LERVIA KH 368 CAR WAXER/POLISHER

[. . . ] Model number: Operating voltage: Power consumption: No load speed: Sound pressure level: Vibration: Overload fuse KH 368 230V ~ 50 Hz 230W n0 = 3000 rpm/orbital 80 dB(A) 14 m/s2 · To avoid danger to life from electric shock: Do not operate the tool if it has a damaged mains lead or plug. Have any tools or mains leads that do not work properly or are damaged examined and repaired at a service centre. The service centre for your country can be found on the guarantee card. [. . . ] Do not carry the tool in such a way that the switch could be inadvertently operated. Look out in particular for any damage to the mains lead (cracks, exposed wires, breaks). Always disconnect from the socket by pulling the plug and never the lead itself. If the original mains lead is not long enough, use an extension cable that is suitable for the purpose, tested and approved, with a current rating of at least 10 A. Look for the presence of an appropriate marking in accordance with the applicable standards on the extension lead. Take or send a defective tool to a specialist repair centre or to the importer's service department (see guarantee information). Do not store the tool to temperatures below 0°C or above 50°C. Always make sure that the bonnet used is firmly attached to the cushion. Before you switch on the tool, check that the cushion is not restrained and can move without causing any danger. Wait until the cushion is in good contact with the surface to be polished before switching on the waxer/polisher. Always follow this operating advice and keep the operating instructions safe in case you need them later. If you pass the tool on to anyone else, please ensure that you also pass on the instructions. Check that the mains voltage corresponds with that given on the rating plate. Devices suitable for 230 V supplies can also be used with 220 V supplies. First use/ normal use Follow the working methods given on the packaging. In order to achieve a thin complete covering do not use more material than is absolutely necessary. [. . . ] ⷠWhen working, always follow the instructions given for the wax/polish. Ask at your local council offices about the disposal of your worn-out tool / bonnet. 21, D-44867 Bochum, Germany, hereby declare that this product conforms with the following EC regulations: Machinery Directive: EU Low Voltage Directive: Electromagnetic compatibility: Applicable harmonised standards: Type/Description: Bochum, 31. [. . . ]