User manual LERVIA KH 1282 STEAM IRON

[. . . ] Stand the steam iron only on its back end, or lay it in the support tray provided on the ironing board. Connect the steam iron only to correctly installed wall power sockets. To avoid possible dangers, arrange for a defective appliance to be checked and possibly repaired by qualified techni-cians, or contact our Customer Service Department. Arrange for defective power cables to be replaced immediately by qualified technicians, or contact our Customer Service Department. [. . . ] Note: On the first use, a light odour development - caused by manufacturing residues - may occur. Q Spray button w Heating control lamp e Power cable with plug r Flexible cable restrainer t Back end y Water tank u Temperature controller i Sole of the iron o Water fill opening a Water jet s Steam controller/Self Clean d Steam blast button f Measuring beaker To extend the optimal steam blast function, mix mains water with distilled water according to the table. Local water hardness very soft / soft medium hard very hard You require water to be able to use the steam and spray functions. Place the cooled down iron in an upright position on its back end t. Using the measuring beaker f, pour in water to no further than the "Max" marking in the water tank y. Should the mains water at your locality be rated as hard, it is recommended that you mix mains water with some distilled water. Otherwise, the jets for the steam blast function could calcify (become blocked) prematurely. Always observe the ironing and care instructions given for the material. If you are not sure what material has been used in the garment, first of all carefully iron a small area (hem-piece or an inner edge). When you have found the temperature which gives the best ironing results, do not increase the temperature further. Never raise the temperature so high that the material of the garment could be damaged. avoid ironing over zippers and studs , as these can scratch the sole of the iron i. During use, lay the steam iron aside only on its back end t or in the support tray provided on the ironing board. Dry ironing is possible at all temperatures, steam ironing is first possible from the level · , always move the steam controller s to the small steam symbol. Note: Steam ironing is first possible from setting · Notice: Should steam no longer be required, or the setting be adjusted to a temperature lower than · Otherwise, water could leak from the ironing sole i. If the clothing care instructions forbid ironing (Symbol ), the clothing item may not be ironed. Check the care instructions on the labels in the garment to see if it is suitable for being ironed, and at which temperature setting. It prevents the dripping of water from the ironing sole i when the iron is switched off and when steam ironing. When steam ironing, the iron must be set to at least level · Consequently, first set the steam controller s to "Steam" when the temperature control knob u is set to at least level · Otherwise, water could leak from the ironing sole i. Taking the steam iron out of service Remove the power plug from the wall socket. Drain the water tank y in that you open up the water fill opening o and either tip the contents out to the side (see Fig. The steam blast is especially suitable for smoothing difficult to reach parts of a garment. [. . . ] It has been carefully produced and meticulously checked before delivery. Contact your service centre by telephone in case of questions pertaining to the warranty. The warranty covers only material or manufacturing faults, not normal wear or damage to fragile parts such as switches or rechargeable batteries. If this product has been subjected to improper or inappropriate handling, abuse, or interventions not carried out by one of our authorised sales and service outlets, the warranty will be considered void. [. . . ]