User manual LENOXX SL6703
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual LENOXX SL6703. We hope that this LENOXX SL6703 user guide will be useful to you.
Manual abstract: user guide LENOXX SL6703
Detailed instructions for use are in the User's Guide.
[. . . ] This appliance shall not be exposed to dripping or splashing water and that no object filled with liquid such as vases shall be placed on the apparatus. 13.
14.
IB-SL6703(TA)-PRADO-E-091802
ADDITIONAL SAFETY INSTRUCTIONS
1. Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Wall or Ceiling Mounting - The appliance should not be mounted to a wall or ceiling. [. . . ] Press again to resume play after pause.
TIP
If you bump the set or the table it is sitting on, during CD play, the music will stop or skip for a few seconds. This is normal for this type of player.
Go to the next track Go back to the previous track Locate a point in a song
FORWARDS BACKWARDS
or Press and hold down while playing until you find the point. Press DISC CHANGE, or press the DISC button (DISC 1, DISC 2 or DISC 3) directly. on the REMOTE.
Change the discs
TIP
This set has an electronic volume control, you may raise or lower the volume by pressing the VOLUME UP and DOWM buttons.
Cancel 3 discs continuously Press playing function. Remove the CD To turn off the sound instantly Turn off the power
6
Press OPEN/CLOSE (press STOP first). Press the POWER switch, the display will go off.
IB-SL6703(TA)-PRADO-E-091802
REPEAT PLAY
PLAYING CD SONGS (TRACKS) OVER AND OVER
You can play CD tracks over and over in normal or programmed play modes (see page 8).
POWER SWITCH
REPEAT
FUNCTION SWITCH
1. Select the track by pressing or , and then press Press the CD REPEAT button.
.
To repeat
a single track (song)
Press
Press the REPEAT button once
Display shows
REP will flash.
all the tracks (all songs) Press the REPEAT button twice programmed tracks During programmed play, press the REPEAT button twice
REP will be steady on REP is steady on
To cancel Repeat Play
Press the REPEAT button until the REP goes off.
7
IB-SL6703(TA)-PRADO-E-091802
PROGRAMMED CD PLAY
SELECTING YOUR OWN MUSIC PLAYING ORDER
You can make a program of up to 15 tracks to play in the order you want them to be played.
NOTE: Programming is only done during stop mode.
PROGRAM
1 2 3 4 5
During STOP mode, press the PROGRAM button. will flash in the display.
Press the SKIP/SEARCH buttons either or until the desired track shows in the display.
Press the PROGRAM button to confirm, PRG. and the track number being played will show in the display.
To change the current program
Just create a new program following the programing procedure.
To cancel Program Play
Press the STOP button on the main set or STOP/PROGRAM button on the REMOTE control twice, PRG. will disappear from the display.
8
IB-SL6703(TA)-PRADO-E-091802
LISTENING TO THE RADIO 1
FM MODE
Connect the supplied AC power cord (see page 3).
2 63
4
1 2 3 4
Press the POWER switch, the VFD display will turn on. Set the FUNCTION switch to RADIO position.
Set the BAND switch to the proper band position (AM or FM), and set the FM MODE switch to STEREO or MONO.
Tune into the station you prefer using the TUNING control. Adjust for the clearest sound.
5 6
This indicator will light up when receiving FM Stereo broadcasts. You may rotate the TONE control counterclockwise to intensify bass, and clockwise to intensify the treble.
9 IB-SL6703(TA)-PRADO-E-091802
USE THESE BUTTONS FOR ADDITIONAL OPERATIONS
FM MODE FUNCTION
VOLUME
TIP
· If the FM broadcast is
To
Adjust the volume Turn off the Radio
Press or Set
VOLUME control (UP or DOWN). Set the FUNCTION switch to TAPE position or press the POWER switch.
noisy, set the FM MODE switch from STEREO to MONO. set has an electronic volume control, you may raise or lower the volume by pressing the VOLUME UP and DOWN buttons.
· This
To improve AM broadcast The AM antenna is magnetic bar within the reception system. To improve FM broadcast Unwrap and fully extend the FM antenna for the reception best FM reception.
FM ANTENNA
To turn off the sound instantly
Press the MUTE button on the REMOTE.
10
IB-SL6703(TA)-PRADO-E-091802
PLAYING A TAPE 1
2
4
3
Connect the supplied AC power cord (see page 3).
1 2 3
STOP/EJECT
Press the POWER switch, the VFD display will turn on. To record from a radio, set the FUNCTION switch to RADIO position, and tune into the station you want (see page 9). To record from the microphone, set the FUNCTION switch to the TAPE position, and plug the microphone (not included) into the MIC JACK. To record from the DECK A, set the FUNCTION switch to the TAPE position, and follow the steps to play a TAPE (see page 11).
4
RECORD
Press the RECORD button to start recording. (The PLAY button is depressed automatically. )
5
REWIND PLAY
To hear what you recorded, set the FUNCTION switch to TAPE position, then press REWIND and PLAY.
14
IB-SL6703(TA)-PRADO-E-091802
USE THESE BUTTONS ADDITIONAL OPERATIONS
FOR
TIP
·
To erase a recording, just start a new recording, and the old one is automatically replaced. see page 19 for notes on cassettes.
DUBBING SPEED SWITCH
STOP/EJECT
PAUSE
To
Stop recording Pause recording
Press or Set
STOP/EJECT button PAUSE button Press the button again to resume recording. Press the STOP/EJECT button and press the POWER switch, the VFD display will go off.
·
Adjust recording speed when copying tapes
Turn off the power
15
IB-SL6703(TA)-PRADO-E-091802
SINGING ALONG WITH KARAOKE FUNCTION
MICROPHONE JACK
2
VOLUME
Connect the supplied AC power cord (see page 3).
1 2
Insert microphone plug into the microphone jack. [. . . ] During the initial 90 day period after original purchase, we will service or exchange, at no charge, the set that is returned to LENOXX ELECTRONICS CORP. After the initial 90 day period expires, and for a period of 12 months from original purchase, we will repair the unit covering any part(s) that need to be replaced at no charge, but will charge for the cost of labor, return postage paid by Lenoxx. This warranty does not apply to any products which have been subject to misuse, neglect or accident. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE LENOXX SL6703
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual LENOXX SL6703 will begin.