User manual LENOXX PH323

[. . . ] 13 MEMORY SPEAKERPHONE MODEL: PH-323 OPERATING INSTRUCTIONS SPEAKERPHONE WITH LED INDICATOR HANDS-FREE HEADSET INCLUDED 13 MEMORY TELEPHONE (3 ONE-TOUCH & 10 TWO-TOUCH) TONE/PULSE SWITCHABLE DIALING RECEIVER VOLUME CONTROL FLASH & REDIAL/PAUSE BUTTON DESK OR WALL MOUNTABLE HOLD BUTTON WITH INDICATOR PLEASE READ CAREFULLY BEFORE USE IB-PH323(MS)-WM-E-051003 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, the following basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury: 1. Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool. Slots and openings in the cabinet at the back or bottom are provided for ventilation, to protect the phone from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the product on the bed, sofa, rug, or other similar surface. [. . . ] SPEAKERPHONE/HEADSET VOLUME CONTROL - ADJUSTS SPEAKER OR HEADSET VOLUME 12. REDIAL/PAUSE BUTTON - QUICKLY REDIALS THE LAST NUMBER YOU DIALED / MAKES A PAUSE IN DIALING A NUMBER 16. HOLD INDICATOR 5 IB-PH323(MS)-WM-E-052403 INSTALLATION INSTRUCTIONS INSTALLATION TELEPHONE BASE HANDSET STRAIGHT TELEPHONE CORD To Telephone Jack COILED HANDSET CORD 1. Insert the modular plugs of the COILED HANDSET CORD into the jack of the TELEPHONE HANDSET and into the jack on the left side of the TELEPHONE BASE. Insert the modular plugs of the STRAIGHT TELEPHONE CORD into the modular jack at the REAR of the TELEPHONE BASE and into the TELEPHONE WALL JACK (either end can be plugged in). This set is designed to connect directly to a modular jack MODULAR JACK If you have a 4-prong style jack, simply use a modular adaptor (not included). TELEPHONE LINE (4-prong style jack) RINGER SETTING This switch is located on the rear of the set. NOTE: If your RINGER switch is in OFF position, only THIS phone will not ring, other phones in your home on the same line will ring. TONE/PULSE SWITCH Select the type of dialing that you desire or that your telephone system requires. (If your phone doesnt dial out, switch to PULSE. ) PULSE - The phone will dial using rotary pulse dialing. NOTE: Even when your phone is set to pulse service, this phone can be switched to temporary tone dialing for access to services that require tone signaling like button after dialing in pulse and your computer systems. Just press the buttons can now be used for tone signaling for this call only. NOTE: When installation is completed, pick up the HANDSET to listen for dial tone before using speakerphone or headset for the first time. 6 IB-PH323(MS)-WM-E-051003 INSTALLATION INSTRUCTIONS HEADSET CONNECTION Connect the plug of the HEADSET into the HEADSET jack on the right side of the phone. When the phone rings, press the SPEAKERPHONE button, it is not necessary to lift the HANDSET. When you finished the conversation, press SPEAKERPHONE / HEADSET again. Select the desired dialing mode with the TONE / PULSE switch (do this only the first time after installation). Press SPEAKERPHONE / HEADSET to get dial tone - no need to lift the HANDSET. To switch the conversation from speakerphone to private, simply lift the HANDSET or use the HEADSET included. If you start your conversation with the HANDSET and want to switch to speakerphone, press the SPEAKERPHONE / HEADSET button and replace HANDSET. Remember to hang up by pressing the SPEAKERPHONE / HEADSET button again. If you start your conversation with the HEADSET and want to switch to speakerphone, just pull off the HEADSET plug from the jack. NOTE 1: Be sure to notify the other party that you are using the speakerphone mode, the other party may not wish anyone else to hear the conversation. NOTE 2: Adjust the VOLUME of the SPEAKERPHONE to the desired sound level while the other party is talking. If a squealing or whistling sound is heard, reduce the speakerphone volume setting. [. . . ] Keep the phone away from bathtub, water or very high heat and humidity (keep away from stove or radiators). Do not, under any circumstances, disassemble the telephone without disconnecting the cord from the telephone line first. Cleaning the exterior surface of the set should be done on a regular basis. Use a cloth slightly dampened with warm, clean water to remove excess dust and dirt. [. . . ]