User manual LEHEL A803KA

[. . . ] Manufacturers' food storage recommendations should be strictly adhered to. Refer to relevant instructions for food and drink storage under point 13. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. [. . . ] In no circumstances must the plug be used without a correct fuse cover/carrier fitted. If the plug supplied on the mains lead is not suitable for the socket in your home, it should be cut off and disposed of safely, or destroyed, to avoid any possible shock hazard resulting from the plug being inserted into a 13 amp socket elsewhere in the house. General guide to fitting any plug Ensure the lengths of wire inside the plug are prepared correctly. Connections should be firmly made after all conductor strands are entered into the terminal posts. When preparing the cable ends take care not to damage the outer sheath, or the insulation surrounding the inner conductors. Other versions Your refrigerator has a 3-wire mains lead which is intended for connection to a 3-pin plug and a properly earthed socket outlet. IMPORTANT: The wires in the mains lead of this appliance are coloured in accordance with the following code: GREEN-AND-YELLOW: EARTH BLUE: NEUTRAL BROWN: LIVE As the colours of the wires in the mains lead may not correspond with the coloured markings identifiying the terminals in your plug, proceed as follows: the wire which is coloured GREENAND-YELLOW must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green-and-yellow. The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red. In other cases, the circuit to which the refrigerator is connected should be fitted with a 5 amp fuse. 1) - 3-way-switch (D) should be in position 230V. 28 GB Turn thermostat knob (A) clockwise to position 6/MAX. Only after approximately 1 hour will the unit become noticably cool (frost on evaporator). - The temperature can be regulated using the thermostat knob: '0'=off, 1-6 increasing degrees of coolness. - After sufficient cooling (approximately 5 hours), the thermostat position can be set to a lower temperature, between 2-5. - Turn thermostat knob (A) anticlockwise to position '0' (a slight resistance will be felt just before this position). D/C operation Do not use any additional form of energy (mains/gas). A safety fuse must be installed in the electricity supply between battery and refrigerator in a duct. cable lengths Cable cross section 2. 5 mm2 4. 0 mm2 6. 0 mm2 12 V until until until 2. 5 m 4. 0 m 6. 0 m 24 V 5m 8m 12 m It is not necessary to consider the polarity when connecting the unit. Check that the battery voltage and line voltage data correspond to the type-plate on the back of the unit. If no batteries are used independently of the vehicle, the mobile cooler should not be operational when the vehicle is in motion, since the battery can discharge to the extent that the vehicle engine cannot restart when the vehicle is at a standstill. During transport, the door safety button (G) must remain depressed, so that the door is kept in a closed and safe position. Recommendation: before journey, pre-cool the unit using A/C operation. [. . . ] - in the case of gas operation, has the safety pilot knob (regulator) been pressed down long enough?If no liquid movement is evident on shaking the cylinder, then the gas cylinder is empty. When contacting our customer service department, please indicate the unit type, product number, serial number and type of defect. We accept responsibility for the perfect condition of the unit, the guarantee being in accordance with our garantee conditions. 33 GB Gas operation butane (propane): Rated thermal loading: 189 W (195W) Min. [. . . ]