User manual LEGRAND 845 57

[. . . ] Undo and remove the four fixing screws in the rear of the Keypad and remove the rear cover. These switches set the House Code for the Remote Keypad and must be set to the same ON/OFF combination as the DIP switches in all other system devices. PA/Tamper Jumper Link (P1) House Code DIP Switches Anti-Tamper Switch Introduction This Remote Keypad is suitable for use with Friedland Response Wirefree Intruder Alarm systems operating at 433MHz only. The Keypad is used to control the system by using a four digit User Access Code. [. . . ] The Keypad incorporates a Personal Attack (PA) and anti tamper protection features that will immediately initiate a Full Alarm condition when activated. Any attempt to open the casing of the Keypad will immediately initiate a Full Alarm condition even if the system is disarmed, (unless the system is in Service, Test or Programming modes). In addition if a sequence of more than 16 incorrect key presses in entered the keypad will be disabled for the next 15s. The Keypad's User Access Code is independant from any access codes used with Control Panel based systems. Note: If used within a multi-user system such as the SA5, the keypad will register in the event log as "User 6" The Keypad is powered by a 9V PP3 Alkaline battery. Under normal operating conditions this will provide an expected life in excess of 2 years. When the battery level falls below an acceptable level, the "LOW BATT" indicator on the front of the Keypad will flash. When this occurs the batteries should be replaced as soon as possible. Positioning the Remote Keypad The Keypad is suitable for mounting in dry interior locations only. The Keypad should be located within a protected area, so that an intruder cannot reach the Keypad without first activating a PIR or magnetic door contact detector. If the light does not flash, wait five seconds and re-enter the programming sequence from the beginning. Personal Attack/(PA) : Press and hold 1 and 2 together for more than 2 seconds. Battery The "LOW BATT" indicator on the front of the Keypad will start flashing when the Keypad battery level drops too low. The battery should be replaced as soon as possible as follows: Siren Service Mode: To switch the Siren into Service Mode Press ? ? ? ? , (hold). The siren will beep/flash twice and then after approx 10s the siren emits a single long beep (and LEDS flash three times). Ensure that the Control Panel is in Test/Programming Mode, or that the Siren is in Service Mode for single zone systems without a Control Panel, (refer to "System Installation and Operating Manual"). Undo fixing screw at bottom of Keypad and remove from wall mounting plate. Replace and fix the rear cover and then refit and secure the Keypad onto the wall bracket. Remember to return the Siren to Operating Mode and/or the system to Standby Mode as appropriate. Note: The Keypad will retain the User Access code for approximately 15 seconds whilst the battery is removed to be replaced. If the battery is disconnected for longer or has been allowed to run completely flat the User Access code will revert to the factory default (1234) when the new battery is connected. [. . . ] If the battery is disconnected for longer or has been allowed to run completely flat the User Access code will revert to the factory default (1234) when the new battery is connected. The User Access code will then need reprogramming to your own setting. Siren Operating Mode: To switch the Siren into Operating Mode: Single Zone system Press (hold) for approx 10s ??, until the siren emits a single long beep (and LEDS flash three times). [. . . ]