User manual LEGRAND 843 27

[. . . ] Attach a Left Linkage (#22) to the inside of the Strut (#20) on the left side of chassis assembly, as shown in Figure 4, using one screw (#25), one spacer (#26) and one locknut (#6). Joints must pivot freely. 7. Figure 4 8. Figure 5 9. Insert Round Top Tube Plugs (#2) into top of Leg (#1) and Flat Tube Plugs into bottom of Leg (#3) on Top (#40). Insert shoulder Bolt (#4) through Roller Bushing (#5) and bottom hole in Mounting Bracket (#9) as shown in Figure 5, and secure with locknut (#6). See Figure 5. 3 AT LEAST TWO (2) ADULTS ARE NEEDED TO COMPLETE THE REST OF THIS ASSEMBLY! 12. [. . . ] With the help of another adult pick up one "Top Assembly" and slide rollers down into slots on "Upright Assembly". See Figure 6. DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL BOTH TOPS ARE INSTALLED!IT COULD BE KNOCKED OVER CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE. 13. With one adult holding the "Top Assembly" upright, swing Struts (#20) up and attach them to mounting brackets on bottom of "Top Assembly" using one screw (#27), Spacer (#26) and lock nut (#6) for each Strut. Swing Left Linkage (#22) up and attach it to Leg (#1) using one screw (#11), one Spacer (#44) and one lock nut (#6). Swing Right Linkage (#21) up and attach it to lower hole in Leg (#1) using one screw (#11), one Spacer (#44) and one lock nut (#6). Attach Safety Latch (#31) to outside of Leg (#1) on the right side of table using one screw (#28), one step spacer (#29), one spacer (#30) and one lock nut (#6). Note: Safety Latch (#31) should hang behind Right Linkage (#21) once attached. Attach bottom of Safety Latch (#31) to inside of Right Linkage (#21) using one screw (#27), one spacer (#30) and one lock nut (#6). Joint must pivot freely. Figure 8 DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL BOTH TOPS ARE INSTALLED!Dampness and extreme temperature changes can cause the wood to warp, swell, crack or blister. CLEANING YOUR TABLE To clean your table use a soft, damp (NOT WET) cloth only. To prevent damage to your table's playing surface, DO NOT USE ANY CHEMICALS, ABRASIVE OR CLEANING PRODUCTS on your table's playing surface. MAINTENANCE OF YOUR TABLE Be sure to oil all moving parts of your table including the pivot points. This table must be kept indoors to prevent damage to the playing surface. Dampness and extreme temperature changes which occur on patios or similar areas can cause wood to warp, swell, crack or blister. UNLEVEL FLOORS If table does not seem level, it is probably due to uneven or unlevel floors. Set the table in its PLAYING POSITION and move table several inches in different directions to find the best location for the table. If the floor is extremely unlevel, table may not play or operate properly. If table is high in the center, shim up under the outer U-legs. 7 ONE YEAR LIMITED WARRANTY This consumer warranty extends to the original consumer purchase of any ESCALADE® SPORTS Product (hereinafter referred as the "Product"). [. . . ] If table is high in the center, shim up under the outer U-legs. 7 ONE YEAR LIMITED WARRANTY This consumer warranty extends to the original consumer purchase of any ESCALADE® SPORTS Product (hereinafter referred as the "Product"). WARRANTY DURATION: This Product is warranted to the original consumer purchase of a period of one (1) year from the original purchase. WARRANTY COVERAGE: LEGRANDS warrants to the original Consumer Purchaser that any Product of its manufacture is free from defects in material and workmanship when used for the intended purpose under normal use and conditions. THIS WARRANTY IS VOID IF THE PRODUCT HAS BEEN DAMAGED BY ACCIDENT, UNREASONABLE USE, NEGLIGENCE, IMPROPER SERVICE, FAILURE TO FOLLOW INSTRUCTIONS PROVIDED WITH THE PRODUCT OR OTHER CAUSES NOT ARISING OUT OF DEFECTS IN MATERIAL AND WORKMANSHIP . [. . . ]