User manual LA CROSSE TECHNOLOGY WT-8112U

[. . . ] When it does receive the signal, it will change the manually set time into the received time. If reception has been unsuccessful, then the WWVB tower icon will not appear but reception will still be attempted the following hour. WWVB time reception takes place from 12:00 am through 6:00 am each day (attempts WWVB reception every full hour within this time frame). When the time signal is received for example at 1:00 am, the radio-controlled clock will not attempt to receive the WWVB signal for the remaining hours until 6:00 am. [. . . ] If a rechargeable battery is used, the Battery switch should be moved to the SOLAR position AFTER it is has been inserted. To use the included rechargeable Alkaline battery (charged by solar panel): 1. It is important to allow sufficient light to reach the solar panel while activating the solar clock. Make sure the lights are on in the setup room and the solar panel is facing a 60W light bulb or brighter - do not cover with hands or other objects. DO NOT SET THE CLOCK. YEAR The year can be selected sequentially from 2001 to 2029 and will then start over again (default setting 2009). Press and release the SET key to switch to the "Month Setting". MONTH 1. Press and release the SET key to move to the mode "Date Setting". The digits for the date will start flashing on LCD2 (Default setting 1). Note: The date can only be set in conjunction with the selected month. For example, it is not possible to set the date 30 if the month of February is selected. The weekday symbols will be displayed on LCD2 in the pre-set language and flashing. Press and release the SET key to enter the mode "12/24h Time Format Setting". MANUAL SETTINGS Note: If the radio-controlled clock has already successfully received the WWVB time signal and displays the correct time and date, then the Manual settings can be skipped. After completion of the above described procedures in "Setting-up" the manual setting modes can be entered by pressing the SET key. DATE TIME ZONE The time zone can be set between the +/­12 hour range in LCD2. Press the set key until the time zone (LCD2) starts flashing (Default setting "EST -5"). Time zone settings: -12, -11, -10, ALA, PST, MST, CST, EST, ATL, -3, -2, 1, 0, +1, +2. . . +12. Press and release the SET key to enter the "DST Setting". 2. 2. WEEKDAY 12/24H TIME FORMAT DST (daylight saving time) The time format can be display in 12h or 24h (Default setting "12h"). The digits "12" or "24" will start flashing on LCD1. By use of the + key select 12h or 24h time format display. 2. Press and release the SET key to enter the mode "ºC or ºF Temperature Setting". °C OR °F TEMPERATURE The temperature setting can be set to either to °F or °C (Default setting °F). The characters "°F" or "°C" will start flashing on LCD1. By use of the + key select "°F" for temperature display in degrees Fahrenheit or "°C" for degrees Celsius. Press and release the SET key to enter the mode "Solar Mode Setting". SOLAR MODE The Solar Mode is used for saving the power consumption of the rechargeable battery (Default setting ON): 1. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. Gently pull the radiocontrolled clock down to lock the screw into place. Note: Always ensure that the radio-controlled clock locks onto the screw before releasing. WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. [. . . ]