User manual LA CROSSE TECHNOLOGY WT-8005U-B

[. . . ] Now use "" and " "buttons to set the correct 12/24 hour mode. · Press "SET" to confirm your setting, the Hour display starts to flash. Now use "" and ""buttons to set the correct hour. · Press "SET" to confirm your setting, the Minute displays starts to flash. Now use "" and ""buttons to set the correct minute. · Press "SET" to confirm your setting, the Year display 2004 starts to flash. Now use "" and "" buttons to set the correct year. · Press SET to confirm your setting, the Month display starts to flash. [. . . ] When the alarm is active the clock displays the " " icon after the hour. About the Daily Alarms: · After 30 seconds without pressing any button the clock switches automatically from setting mode to Normal clock mode. · The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case the alarm will be repeated automatically after 24 hours. · Rising alarm sound changes the frequency 4 times while the alarm signal is heard. This is known as a "Crescendo Alarm". Automatic Snooze function: · While the alarm is sounding, press the SNOOZE button to activate the snooze function. The " " icon appears on the display. · This operation moves the alarm back by 5 minutes and the alarm will restart at this time. · The Snooze function can be interrupted by pressing any button. Page 6 of 12 °F/°C Temperature Display: · The temperature is displayed either in °F or °C. Briefly pressing the " "button allows you to switch between the temperature modes. Reception of the WWVB Radio signal: · The clock must receive the WWVB Radio Signal to automatically set the time, date and weekday. · The clock automatically starts the WWVB signal search after 7 minutes of any restart or changing of new fresh batteries. The radio tower icon starts to flash. · At 1:00 am, the clock automatically carries out the synchronization procedure with the WWVB signal to correct any deviations to the exact time. If this synchronization attempt is unsuccessful (the radio tower icon disappears from the display), the system will automatically attempt another synchronization at the next full one hour. This procedure is repeated automatically up to total 5 times. · To start manual WWVB signal reception, press the "WWVB SEARCH" button. If no signals received within 7 minutes, then the WWVB signal search stops (the radio tower icon disappears) and will start again at the next full one-hour. · To cancel RC reception and stop searching for the WWVB radio signal, press the "WWVB SEARCH" button once. About WWVB Radio Signal Reception: · A flashing radio tower icon indicates that the WWVB signal reception has started. · A continuously displayed radio tower icon indicates that the WWVB signal was received successfully during the last attempt. If the clock attempts to receive the WWVB signal and Page 7 of 12 is unsuccessful, the tower icon will not be continuously displayed on the LCD. · We recommend a minimum distance of 2. 5 meters (8 feet) to all sources of interference, such as televisions or computer monitors · Radio reception is weaker in rooms with concrete walls (e. g. : in cellars) and in offices. In such environments, place the system close to the window. Online Resources · Visit the WT-8005U page online at: http://www. lacrossetechnology. com/8005 Care and Maintenance · Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and give inaccurate readings. · Precautions shall be taken when handling the batteries. Injuries, burns, or property damage may be resulted if the batteries are in contact with conducting materials, heat, corrosive materials or explosives. The batteries shall be taken out from the unit before the product is to be stored for a long period of time. · Immediately remove all low powered batteries to avoid leakage and damage. Replace only with new batteries of the recommended type. · When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or scouring agents as they may mark the LCD and casings. · Do not submerge the unit in water. Furthermore, fix all parts in place where the units are adequately protected against moisture and rain. · Special care shall be taken when handling a Page 8 of 12 damaged LCD display. The liquid crystals can be harmful to user's health. · Do not make any repair attempts to the unit. Return them to their original point of purchase for repair by a qualified engineer. Opening and tampering with the unit may invalidate their guarantee. · Never touch the exposed electronic circuit of the device as there is a danger of electric shock should it become exposed. · Do not expose the units to extreme and sudden temperature changes, this may lead to reduce their accuracy. · Batteries are the single largest cause of customer support cases. [. . . ] THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do no allow the exclusion of consequential or incidental damages; therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: Hours: Mon-Fri. ­ 8:00 AM to 6:00 PM Central e-mail: support@lacrossetechnology. com La Crosse Technology, Ltd 2817 Losey Blvd. [. . . ]