User manual LA CROSSE TECHNOLOGY WT-8002U

[. . . ] Set Date - Month Once the year is set, press the "SET" button again and the Month digits will flash. Use the "+" and "- / F°/C°" buttons to select the correct month. Set Date - Date Once the month is set, press the "SET" button again and the Date digits will flash. [. . . ] Press the "ALM" button to confirm your minutes setting and to end the setting procedure. To activate or deactivate the daily alarm: Briefly press the "ALM" button once. When the alarm in the is active the clock displays the alarm icon upper right corner. About the Time Alarm: After 15 seconds without pressing any button, the clock switches automatically from alarm setting mode to normal clock mode. To Use The Alarm The alarm can be silenced by pressing any button. If it is not silenced, it will sound for 2 minutes before stopping on its own. The alarm repeats automatically after 24 hours. Page 3 of 8 Page 4 of 8 If the "SNZ" button is pressed, the alarm will silence for approximately 5 minutes, after which it will begin to sound again. The alarm uses 3 different patterns of tone, beginning gently and increasing in intensity, known as a "Crescendo Alarm". Immediately remove all low power batteries to avoid leakage and damage. Do not use solvents or scouring agents as they may mark the LCD and casings. Furthermore, fix all parts in place where the units are adequately protected against moisture and rain. Never touch the exposed electronic circuit of the device as there is a danger of electric shock should it become exposed. Do not expose the units to extreme and sudden temperature changes, as this may lead to reduce their accuracy. Battery Replacement Information To replace the battery: 1. Please take note to install the battery with the proper polarity as it relates to the battery diagram inside the battery compartment (+). To avoid start-up problems please ensure that the battery does not spring free. Please take any used batteries to an authorized depot for recycling. 2. 3. Mounting the Unit The clock can be set on a table or mounted onto a wall. Table Standing An easel type foldout stand is located on the bottom of the back side of the clock. Align the hanging hole to the mounting screw and ensure that the clock locks down into place before releasing it. Troubleshooting Battery: Battery problems are the single largest cause of customer support cases. [. . . ] LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do not allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. [. . . ]