User manual LA CROSSE TECHNOLOGY WT-2165 INSTRUCTION MANUAL

[. . . ] If the WWVB time has not been received after 10 minutes of battery installation, you may manually set the time or wait for the WWVB reception. About Radio-Controlled Time signal, WWVB: The NIST (National Institute of Standards and Technology--Time and Frequency Division) WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact time and date signal continuously throughout the United States at 60 kHz. The signal can be received up to 2, 000 miles away through the internal antenna in the alarm clock. However, due to the nature of the Earth's Ionosphere, reception is very limited during daylight hours. [. . . ] k) Press and release the "+" key to advance to the correct hour; be sure to note the correct am/pm setting ("PM" will show for hours between 12 noon and midnight). By holding the "+" key, the minutes will advance in five minute increments. q) Press and release the "+" key to advance to the correct year. t) Press and release the "+" key to advance to the correct month. w) Press and release the "+" key to advance to the correct day. y) The day of the week will now flash (Sun, Mon, etc. ). 4 z) Press and release the "+" key to advance to the correct day of the week. cc) Press and release the "+" key to select either 12 ­hour or 24-hour (military time). dd) Press and release the "SET" key to complete the programming. The programming is now complete. D. SETTING THE ALARMS La Crosse Technology's travel alarm clock has two separate alarms that can be set. a) Press and hold the "ALM1" (or "ALM2" key) key for two seconds to enter the setting mode. c) Press and release the "HOUR" key to advance the hour of the alarm, and press and release the "MIN" key to advance the minutes of the alarm. Note: If no button is pressed within fifteen seconds, the alarm will set and activate, and the clock will revert to the normal operating screen. The picture below shows both alarms activated. "Alarm 1" activated "Alarm 2" activated Activating the Alarms To activate/deactivate the alarm, press and release the "ALM1" or "ALM2" key once, depending on which alarm needs to be activated. Activating the SNOOZE function When the alarm is sounding, pressing the top of the unit gently backwards will activate the snooze for the time that was selected in the programming mode. If the setting is "0", the alarm will turn off for 24 hours. During the snooze period, the lower screen will show a countdown until the alarm will sound again. If the snooze is activated again during the original snooze period, the period will be reset. Pressing any key other than the snooze will turn off the alarm for 24 hours. III. The exact time will always be displayed in the upper portion of the screen, and the US map will show when the time zone is set to the continental US (with the time zone 5 selected showing in black). The lower portion of the screen has five different screens that can be selected. Press and release the "MODE" key to select which screen to show. While in non-alarm mode, pressing the "SNOOZE" bar will show the "ALARM1" and "ALARM2" briefly in the lower section. IV. [. . . ] This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the units' inability to receive a signal due to any source of interference. LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS UNIT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do not allow the exclusion of consequential or incidental damages; therefore the above exclusion of limitation may not apply to you. [. . . ]