User manual LA CROSSE TECHNOLOGY WS-8500TWC-IT

[. . . ] Then the current temperature will appear on the sensor's LCD and it will start to transmit the wireless temperature signal. Note: When the voltage of the TX61U-IT sensor is lower than 2. 5V, the transmission of signal stops and "LO" is displayed on the LCD for approximately 2 seconds before the sensor enters into the "IDLE" mode. The sensor will check and charge up the internal rechargeable battery automatically. When the battery voltage rises up to 2. 5V, the LCD will turn on and transmission of signal will start again. Wireless Weather Instruments by La Crosse Technology® Step 2. x x x x x 3. La Crosse Technology, Ltd. [. . . ] Use the "PLUS" button to set the time mode to either a 12 or 24 hour clock. Set Temperature Mode - °F or °C: Press the "SET" button an eleventh time and the Temperature Mode abbreviation will flash. Use the "PLUS" button to set the temperature mode to °F or °C. Setting the Time Alarm x To set the Alarm Time - Minutes: The Minutes digits of the Alarm Time will flash. You can hold the "PLUS" button in to speed up the setting of minutes by using five minute increments. Press the "ALARM" button to confirm your minutes setting and to end the setting procedure. To activate or deactivate the daily alarm, briefly press the "ALARM" button once. When the alarm is active the clock displays the alarm icon below the word "TIME", when the alarm is deactivated, the alarm icon will not display. x About the Time Alarm: x x x After 15 seconds without pressing any button the clock switches automatically from alarm setting mode to normal clock mode. The alarm uses 3 different patterns of tone, beginning gently and increasing in intensity, known as a "Crescendo Alarm". Battery Replacement Information Wireless Display To replace the batteries in the Wireless Display: 1. Please take note to install the batteries with the proper polarity as it relates to the battery diagram inside the battery compartment (+). To avoid start-up problems please ensure that the batteries do not spring free. Replace compartment cover. 3. Please follow the "SETTING UP" steps listed in the previous section of this manual to ensure that the wireless temperature reception is successful. TX61U-IT Wireless Solar-Powered Sensor DOES NOT have replaceable batteries. The TX61U-IT sensor consumes solar power and automatically charges the internal Alkaline power cell. Please take the used batteries to an authorized depot for recycling x x To turn the alarm on: Press the "ALARM" button. the alarm icon To set the Alarm Time - Hour: Press and hold down the "ALARM" button for 2 seconds until the hours digits flash. Press the "ALARM" button to confirm your setting and move to setting the minutes. Page 7 of 14 Page 8 of 14 Installation Notes x Point the TX61U-IT solar panel toward the best available indirect light to recharge the batteries, but avoid a location in direct sun as it will cause incorrect temperature readings. The TX61U-IT sensor consumes solar power and uses the internal rechargeable batteries to store the collected power. The sensor features a high-efficiency modern solar panel that maintains a full charge with minimal indirect light; do not place in direct sun. Fog and mist will not harm the sensor but direct rain must be avoided. Replace only with new batteries of the recommended type. Mounting the Units THE TX61U-IT Sensor The sensor can be set on a table or mounted onto a wall using the included screws x x x x x When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or scouring agents as they may mark the LCD and casings. [. . . ] THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do not allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information, please contact: La Crosse Technology, Ltd 2809 Losey Blvd. La Crosse, WI 54601 Phone: 608. 782. 1610 Fax: 608. 796. 1020 For online contact / support / e-mail: www. lacrossetechnology. com/support For information on other products: sales@lacrossetechnology. com FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. [. . . ]