User manual LA CROSSE TECHNOLOGY WS-811561-W

[. . . ] La Crosse Technology® WS-811561 IT915 MHz Atomic Digital Clock and Temperature Station with Wireless Solar-Powered Outdoor Temperature Sensor Wireless Weather Instruments by La Crosse Technology® La Crosse Technology, Ltd. S La Crosse, WI 54601 Phone 608-782-1610 Table of Contents Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Inventory of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Set the Time and Date. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Language choices include: US: English (default setting) F: French (Français) E: Spanish (Español) d: German (Deutsch) 2. 3. Page 5 of 12 4. Set Time - Hour: Press the "SET" button a fourth time and the Hours digits will flash. Set Time - Minute: Press the "SET" button a fifth time and the Minutes digits will flash. Set Date - Year: Press the "SET" button a sixth time and the Year digits will flash. Set Date - Month: Press the "SET" button a seventh time and the Month digits will flash. Set Date - Date: Press the "SET" button an eighth time and the Date digits will flash. Set Date - Day of Week: Press the "SET" button a ninth time and the Day of Week abbreviation will flash. Use the "PLUS" button to set the correct day of week. 5. 6. 7. 8. 9. 10. Set 12 or 24 Hour Time Mode: Press the "SET" button a tenth time and the 12 or 24 Hour Time Mode digits will flash. Use the "PLUS" button to set the time mode to either a 12 or 24 hour clock. Set Temperature Mode - °F or °C: Press the "SET" button again and the Temperature Mode abbreviation will flash. Use the "PLUS" button to set the temperature mode to °F or °C. Setting the Time Alarm 1. To set the Alarm Time - Hour: Press and hold down the "ALARM" button for 2 seconds until the hours digits flash. Press the "ALARM" button to confirm your setting and move to setting the minutes. To set the Alarm Time - Minutes: Page 6 of 12 The Minutes digits of the Alarm Time will flash. You can hold the "PLUS" button in to speed up the setting of minutes by using five minute increments. Press the "ALARM" button to confirm your minutes setting and to end the setting procedure. To activate or deactivate the daily alarm: Briefly press the "ALARM" button once. When the alarm is active the clock displays the alarm icon below the word "TIME", when the alarm is deactivated, the alarm icon will not display. About the Time Alarm: After 15 seconds without pressing any button the clock switches automatically from alarm setting mode to normal clock mode. The alarm uses 3 different patterns of tone, beginning gently and increasing in intensity, known as a "Crescendo Alarm". Battery Replacement Information Wireless Display To replace the batteries in the wireless display: 1. Please take note to install the batteries with the proper polarity as it relates to the battery diagram inside the battery compartment (+). To avoid start-up problems please ensure that the batteries do not spring free. [. . . ] TX61U-IT sensor LCD is turned "OFF": Pease read step 1 of the Initial Setup. . . section on page 3 or "TX61U-IT sensor Power Save "STOP" Mode" on page 4. Warranty Information La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. [. . . ]