User manual LA CROSSE TECHNOLOGY WS-6010U-IT

[. . . ] Then the transmitter enters STOP mode. Idle Operation Mode: This mode occurs when the battery voltage drops lower than 2. 4V. If battery voltage is raised higher than 2. 5V, the unit will go into Normal mode. If the solar transmitter is placed into a dark environment for 72 hours, the will go into Stop mode. Stop Operation Mode: This mode occurs when the solar transmitter is placed into a dark environment for 72 hours or the user covers the solar cell for 10 seconds and presses the RESET button. [. . . ] The distance between the Solar Station and the transmitter should not be more than 200 feet (60. 96m) to ensure sufficient 915 MHz transmission. (see notes on "Positioning" and "915 MHz Reception"). Always wait at least 10 minutes after removing batteries before re-inserting; otherwise start up problems may occur. 3. TO SET THE TIME Note: The time will be displayed with "AM" or "PM" for the time from 12:00 noon until 11:59. Press and hold the SET key for 3 seconds to enter the time setting mode. Set the desired hours by pressing and releasing the + key followed by pressing the SET key. Press the SET key again to confirm and enter the Solar Mode setting. SOLAR MODE The Solar Mode is used for saving the power consumption of the rechargeable battery (Default setting ON): 1. By use of the + key select "ON" or "OFF" to set the solar mode. Press and release the SET key to exit the setting mode and switch back to the normal display mode. If the solar mode setting is ON: The surrounding environment brightness is checked every 5 seconds. No information will be displayed when the LCD is OFF, but all the settings and operations will remain, except for the temperature and humidity measurements. If the solar mode setting is OFF: LCD will remain ON constantly. STOP MODE If the Solar Station is placed in a dark environment for 72 hours continually, the clock will go to the stop mode: The most power saving condition. 7 The Solar Station will not perform any operation and the LCD will also be OFF. Press any key to wake up the Solar Station and to re-activate the transmission with the solar transmitter. MIN/MAX: Press and release the PLUS button to view: Outdoor Temperature minimum and maximum. RESET MIN/MAX: Press and hold the PLUS button for 10 seconds to reset the indoor and outdoor minimum and maximum temperatures to current temperatures. DISPLAY MODES: Press and release the SET button to view Shows outdoor temperature in the first line on the left side and outdoor humidity in the second line on the left side. Shows indoor temperature in the first line on the right side and indoor humidity in the second line on the right. Shows outdoor temperature in the first line on the left side and outdoor humidity in the first line on the right side. Shows indoor temperature in the second line on the left side and indoor humidity in the second line on the right side. Shows indoor temperature in the first line on the left side and indoor humidity in the first line on the right side. Shows outdoor temperature in the second line on the left side and outdoor humidity in the second line on the right side 8 915MHZ RECEPTION CHECK FOR OUTDOOR SOLAR TRANSMITTER The Solar Station will receive the outdoor data every 48 seconds. If the temperature data is not being received 2 minutes after setting up (or the display shows "- - -"), then please check the following points: 1. The distance of the Solar Station or outdoor transmitter should be at least 6 feet (2 meters) away from any interfering sources such as computer monitors or TV sets. Avoid placing the receiver onto or in the immediate proximity of metal window frames. [. . . ] To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. [. . . ]