User manual LA CROSSE TECHNOLOGY WS-2812-IT QUICK SETUP MANUAL

[. . . ] The "+" markings on the batteries must line up with the diagrams inside the battery compartments. Inserting the batteries incorrectly may result in permanent damage to the units. During the setup process, place the wireless display and the outdoor sensors on a surface with 3-10 feet between the sensors and the display. [. . . ] If not successful within 4 minutes, the thermo-hygro sensor will stop looking for the other sensors. Setup troubleshooting: If the sensor data fails to display for any of the outdoor sensors within 10 minutes, ("- - -" is displayed), remove the batteries from all units for 1 minute and start the Setup procedure again at Step 1. Pressure History Graph Wind Direction Barometric Pressure Wind Speed Forecast Icon and Weather Tendency Arrows Time and Date Wind Chill Indoor Temperature Indoor Humidity Outdoor Temperature Outdoor Humidity Rainfall Amount Mounting the sensors and placement of the wireless display: IMPORTANT: Ensure that all of the sensor data can be received at the intended mounting locations before you drill mounting holes. Keep in mind that the 200 foot range equates to an open air scenario with no obstructions. Each obstruction (roof, walls, floors, ceilings, etc. ) will reduce the range. The thermo-hygro sensor measures outdoor temperature & humidity and collects the data from the wind and the rain sensors and sends all outdoor weather data to the wireless display, so the thermo-hygro sensor must be within the 200 foot wireless range of the wireless display. This allows the wind and rain sensors to be placed relative to the thermo-hygro sensor rather than the wireless display. The wind and rain sensors must be mounted within the 200 foot wireless range of the thermo-hygro sensor and on the same side of the house. The wireless display must be within the 80 foot wireless range of the USB transceiver to send weather data to the PC. If the sensor wireless icons drop from the display as you move them into their intended locations, the sensors may be too far from the wireless display. Try moving the wireless display or the sensors closer and wait a few minutes to see if the wireless icons display again. If the wireless icons are still not displayed after re-positioning the sensors or the wireless display, press and hold the UP ARROW () key for 2 seconds to re-synchronize the wireless display with the sensors. Wind sensor The wind sensor must be installed with the front of the sensor (the solar panel) facing true South, or the reported wind direction will not be accurate. Mount within the 200 foot wireless range of the thermo-hygro sensor and on the same side of the house. Use the right-angle adaptor if the wind sensor will be mounted on a horizontal mast or surface. Fasten the wind sensor to a suitable mast using the two U-bolts, washers and nuts included. Note: Mount the wind sensor onto a mast so the wind can reach the sensor unobstructed from all directions for an accurate reading. The wind sensor DOES NOT have replaceable batteries - it consumes solar power and charges the internal battery pack automatically. [. . . ] Note: After mounting the units, if the weather data is not received, press and hold the UP ARROW () key for 2 seconds to synchronize the wireless display to the sensors. Heavy Weather PC Software Use your PC to store and graph the latest weather data collected by the weather station. Download the Heavy Weather PC software from www. lacrossetechnology. com/support. See the download page for installation instructions and computer requirements. FCC DISCLAIMER This device complies with part 15 of the FCC rules. [. . . ]