User manual LA CROSSE TECHNOLOGY TX18U

[. . . ] (The remote temperature/humidity sensor powers the wind speed sensor and the rainfall sensor so no batteries are required. ) 2. Important Notes on Set-up and Operation · The remote temperature/humidity sensor is both the source of power for both outdoor sensors and source of transmission for all remote sensor data. · The remote temperature/humidity sensor should be placed in a dry, shaded area. [. . . ] THE REMOTE TEMPERATURE/HUMIDITY SENSOR The remote temperature/humidity sensor can be mounted in several ways: · With the use of screws · Using adhesive tape · Using nylon straps A. MOUNTING WITH SCREWS 1) Remove the mounting bracket from the remote temperature/humidity sensor. 3) Through the two screw holes of the bracket, mark the mounting surface with a pencil. MOUNTING WITH ADHESIVE TAPE 1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. 3) Adhere the tape to the designated area on the back of the mounting bracket. 5) Position the remote temperature/humidity sensor in the desired location, ensuring that the indoor weather station can receive the signal. MOUNTING WITH NYLON STRAPS 1) Remove the mounting bracket from the remote temperature/humidity sensor. 3) Place the remote temperature/humidity sensor in your desired mounting location. MAINTENANCE AND CARE INSTRUCTIONS · Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. Do not use solvents or scouring agents; they may mark the displays and casings. · Immediately remove all low powered batteries to avoid leakage and damage. Contact La Crosse Technology for repairs. 3 SPECIFICATIONS Weather data measuring range: Outdoor and dew point: Outdoor relative humidity measuring range: -21. 8°F to 157. 8°F with 0. 2°F resolution (-29. 9°C to 69. 9°C with 0. 1°C resolution) "OFL" displayed if outside this range 1% to 99% with 1% resolution ("- - " displayed if outside this range Total rainfall: 0 to 2499 mm with 0. 1 mm resolution (0 to 98 inch with 0. 02 inch resolution) 330 feet (in open space) 2 x AA, IEC LR6, 1. 5V Approximately 12 months Alkaline 5. 4" x 2. 25" x 2. 25" (137 x 56. 2 x 56. 2 mm) WARRANTY INFORMATION Transmission range: Power Supply: Remote temperature/humidity sensor: Battery life cycle: Recommended battery type: Dimensions (H x W x D): Remote temperature/humidity sensor: La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. [. . . ] (2) This device must accept any interference received, including interference that may cause undesired operation. 433. 92 MHz La Crosse Technology Made in China TX8U All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher. [. . . ]