User manual LA CROSSE TECHNOLOGY BC1000 QUICK SETUP MANUAL

[. . . ] 4. Charging current range Max charging capacity (capacity of rechargeable batteries) 4. CURRENT key DISPLAY key 5. MODE key Press and hold the MODE key for 2 seconds, within 8 seconds from inserting the battery. Press and release the MODE key to select Charge, Discharge, Refresh or Test mode, If no key is pressed, it will change to show "200 mA" and "Charge" and will start charging at 200 mA after 4 seconds. Within 8 seconds after inserting the batteries, select the charging current by pressing the CURRENT key. (1500 & 1800 mA can only be selected if one or two batteries only are charged (bays 1 & 4 only)). [. . . ] Note: The charging current of the second, third and fourth battery placed in to the charger cannot be set higher than that of the first battery. Therefore user should place the battery with the highest desired charging current in compartment 1. Stage in Charge mode During charging Full stage Various displays (toggled by pressing DISPLAY key) Time Capacity Voltage (V) Current (mA) (hh:mm) (mAh/ Ah) Charging current Instantaneous Charging time Accumulated Trickle battery voltage elapsed capacity charging current 6. 7. Once charging has started, the current can no longer be changed. Within 8 seconds from inserting the battery into compartment 3, press the corresponding compartment key "3". 3 is pressed 8. 9. 10. 11. Within 8 seconds from pressing the compartment key, press and hold the MODE key for 2 seconds then press and release the MODE key to select the "Test" mode for compartment 3. Note: Press the compartment key to select a particular compartment before pressing the MODE key, otherwise, the mode of all the compartments will be changed at the same time. Within the 8 seconds after the last key press, select the charging current in the test mode: 200, 500 or 700 mA Note: Although the individual bays are operated in different modes, the charging current of the second, third and fourth battery placed into the charger cannot be set higher than that of the first placed battery. 8 seconds after the last key press, the display will blink once to indicate that the time allowed for setting is over and the Test mode will start. Now the batteries in compartments 1 and 2 are being charged, while the battery at compartment 3 is undergoing Test mode. Within 8 seconds of placing a battery into compartment 4, press the corresponding compartment key "4". The battery will then catch the clip that is meant for the AAA batteries. If you do not get the AAA battery flat into the compartment, the battery will not catch the correct clip and will not charge. return shipping charges to the owner of the product to a USA address only. Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage occurring during shipment (claims must be presented to the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner's manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use (7) applications and uses that this product was not intended or (8) the products inability to receive a signal due to any source of interference. . This warranty covers only actual defects within the product itself, and does not cover the cost of installation or removal from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the seller or performance variations resulting from installation-related circumstances. LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: CAUTION: This charger is restricted to charging NiCd and NiMH rechargeable batteries only. Never use this charger for other types of batteries such as alkaline, lithium, carbon zinc or other types that are not specified. [. . . ] South La Crosse, WI 54601 The complete instruction manual is available at: www. lacrossetechnology. com/support Le manuel d'instruction complet est disponible sur: www. lacrossetechnology. com/support El manual de instrucciones completo está disponible en: www. lacrossetechnology. com/support WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. [. . . ]