User manual LA CROSSE TECHNOLOGY 515-1316

[. . . ] The atomic clock will search for a signal every night when reception is best. The clock receives the time signal via its built-in antenna and adjusts automatically to the selected time zone. Once the correct time is set, the clock continues running with an internal quartz-controlled mechanism. [. . . ] Press and release the MODE/SET button to confirm and continue to the next menu item. Year flashes DATE FORMAT: M and D will flash by the date. Press and release the PLUS button or the MINUS button to select the date displayed in Month/Day or Day/Month format. Press and release the MODE/SET button to confirm and continue to the next menu item. M & D flash MONTH: The month will flash. Press and release the PLUS button or the MINUS button to adjust the month. Press and release the MODE/SET button to confirm and continue to the next menu item. Month will flash 1M 1D 1M 1D DATE: The date will flash. Press and release the PLUS button or the MINUS button to adjust the date. Press and release the MODE/SET button to confirm and continue to the next menu item. NOTE: Day of the week will set automatically. Date will flash DST: DST (Daylight Saving Time) will flash with ON or OF in the second display. Press and release the PLUS button or the MINUS button to turn the DST indicator OF (off) or ON. This indicator is defaulted to ON and will only need to be turned off is you live in an area that does not observe DST. Press and release the MODE/SET button to confirm and exit the program menu. DST Flashes ON or OF shows steady where the seconds are displayed. OTHER SETTINGS: begin from normal time display. 12/24-HOUR TIME: From a normal display press and release the 12/24 button to switch from 12-hour time format to a 24-hour time format. 12-hour time format will show AM in front of the time for morning hours and PM for afternoon/evening hours. WWVB SEARCH: Hold the tower button for 5 seconds to activate the WWVB signal search. It is best to activate at night when atmospheric disturbances are usually less severe. TIME ALARM SET: Press and release the MODE/SET button once to enter Alarm Mode. "AL" should appear after the alarm time. 7:00 AL HOUR: From Alarm Mode hold the MODE/SET button for 5 seconds and the hour will flash. Press and release the PLUS button or the MINUS button to adjust the hour. Press and release the MODE/SET button to confirm and continue to the minutes. MINUTES: The minutes will flash. [. . . ] The owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center. Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage occurring during shipment (claims must be presented to the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner's manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use (7) applications and uses that this product was not intended or (8) the products inability to receive a signal due to any source of interference. This warranty covers only actual defects within the product itself, and does not cover the cost of installation or removal from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the seller or performance variations resulting from installation-related circumstances. [. . . ]