User manual LA CROSSE TECHNOLOGY 404-1210S

[. . . ] When the tower icon flashes, but does not set the time or the WWVB tower does not appear at all, take note of the following: Recommended distance to any interfering sources like computer monitors or TV sets is a minimum of 6 feet (2 meters). Within ferro-concrete rooms (basements, superstructures), the received signal is naturally weakened. In extreme cases, please place the unit close to a window and/ or point its front or back towards the Fort Collins, Colorado, transmitter. During nighttime, the atmospheric disturbances are usually less severe and reception is possible in most cases. [. . . ] -Hold to set Time Alarm in Alarm mode. + 12/24 BUTTON: -Press and release to select 12-hour or 24-hour time -Hold to select Time Zone -When programming, press and release to change a value. - BUTTON: -When programming, press and release to change a value. -Hold to activate/deactivate WWVB search. MANUAL TIME SET: Set the Time Zone First. Release then hold the 12/24 button again to change the time zone a second time. E-Eastern Time C- Central Time M- Mountain Time P-Pacific Time Time Zone will display to the right of the time. P M CE HOUR: From normal display hold the MODE/SET button for 5 seconds and the hour will flash. Press and release the PLUS button or the MINUS button to adjust the hour. Press and release the MODE/SET button to confirm and continue to the next menu item. Hour Flashes 12:04 05 12:07 12:09 2007 1M 1D 48 Minutes Flash MINUTES: The minutes will flash. Press and release the PLUS button or the MINUS button to adjust the minutes. Press and release the MODE/SET button to confirm and continue to the next menu item. SECONDS: The seconds will flash. Press and release the PLUS button or the MINUS button to adjust the seconds. Press and release the MODE/SET button to confirm and continue to the next menu item. 55 Seconds Flash YEAR: The year will flash. Press and release the PLUS button or the MINUS button to adjust the year. Wall Mount: Insert three screws (not included) into the desired wall, about 3. 9 inches (10 cm) apart. Carefully hang the clock on the screws, using the hanging holes on the back of the clock. NOTE: Always ensures that the unit locks onto the screws before releasing. Place on table or desk as desired. Wall Hanging Holes Function Buttons Battery Compartment Base Stand SPECIFICATIONS: Dimensions: 15. 35 inches H x 19. 09 inches W x 1. 57 inches D (39 cm H x 48. 5 cm W x 4 cm D) Power: Requires three "C" IEC LR14 alkaline batteries (not included). Important: Do Not Mix Old and New Batteries Do Not Mix Alkaline, Standard, or Rechargeable Batteries Remove batteries when clock is not in use or when in storage. Avoid placing clock in high humidity environments such as poolside or in a bathroom. Do not expose clock to direct sunlight or extremely hot or cold temperatures. WARRANTY INFORMATION: La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. [. . . ] La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. If necessary repairs are not covered by this warranty, or if a product is examined which is not in need or repair, you will be charged for the repairs or examination. The owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center. Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage occurring during shipment (claims must be presented to the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner's manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use (7) applications and uses that this product was not intended or (8) the products inability to receive a signal due to any source of interference. [. . . ]