User manual LA CROSSE TECHNOLOGY 404-1210

[. . . ] Note: After batteries are installed in the transmitter, install the batteries in the weather center to receive the signal from the transmitters as soon as possible. If the weather center is powered more than 5 hours after the transmitter is powered, the weather center will never receive the signal successfully from the transmitters. In this case, you will need to reinstall the batteries for all the transmitters to redo the setup procedure. [. . . ] When the signal is successfully received by the Weather Center, the icon will be switched on. (If it is not successful, the icon will not be shown in LCD) This allows you to see whether the last reception was successful (icon on) or not (icon off). Note: When changing batteries in any of the units, all units need to be reset by following the setup procedures. This is because a random security code is assigned by the thermohygro sensor at start-up and this code must be received and stored by the weather center in the first several minutes of power being supplied to it. When the batteries need to be replaced, the low battery symbol will appear on the LCD. If the signal reception is not successful on the first frequency (915MHz) for 45 seconds, the frequency is changed to 920MHz and the learning is tried another 45 seconds. If still not successful, the reception is tried for 45 seconds on 910MHz. Note: When changing batteries in any of the units, all units need to be reset by following the setup procedures. This is because a random security code is assigned by the transmitter and rain sensor (optional) at start-up and this code must be received and stored by the Weather Station in the first 90 seconds of power being supplied to it. Note: After mounting the units, should the weather data not be received, user may need to remove the batteries from all units and redo the set-up procedures after about 5 minutes. Note: To view the rainfall data, press the + key after entering Mode 2 display. The rain sensor should be mounted horizontally about 2-3ft off from the ground (or higher) in an open area away from trees or other coverings to allow rain to fall naturally for an accurate reading. Note: For best results ensure the base is horizontal to allow maximum drainage of any collected rain In Mode 2, this reception icon is showing the condition of the reception of the signal from Rain sensor (only if a rain sensor is being used) La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. [. . . ] La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. If necessary repairs are not covered by this warranty, or if a product is examined which is not in need or repair, you will be charged for the repairs or examination. The owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center. [. . . ]