User manual LA CROSS TECHNOLOGY WT-5442

[. . . ] QUICK SET-UP GUIDE 1) Insert two AA batteries into the remote transmitter. 2) Insert three AA batteries into the projection alarm and/or plug into wall. Note: When starting or restarting your projection alarm the remote transmitter must be started first and then your alarm. After power is supplied (either battery or AC) ensure that no buttons are pressed for 10 minutes. [. . . ] The NIST (National Institute of Standards and Technology--Time and Frequency Division) WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact time signal continuously throughout the United States at 60 kHz. The signal can be received up to 2, 000 miles away through the internal antenna in the Projection alarm. Due to the nature of the Earth's Ionosphere, reception is very limited during daylight hours. The Projection alarm will search for a signal every night when reception is best. The WWVB radio station receives the time data from the NIST Atomic clock in Boulder, Colorado. A team of atomic physicists is continually measuring every second, of every day, to an accuracy of ten billionths of a second per day. These physicists have created an international standard, measuring a second as 9, 192, 631, 770 vibrations of a Cesium-133 atom in a vacuum. This number will connect 9 you to an automated time, announced at the top of the minute in "Coordinated Universal Time", which is also known as Greenwich Mean Time (GMT). It is possible that your Projection Alarm may not be exactly on the second due to the variance in the quartz. However, the clock will adjust the quartz timing over the course of several days to be very accurate; under 0. 10 seconds per day. When plugged into an AC outlet, the projection alarm can continuously project the time and/or remote temperature. When operating on batteries alone, the Projection Alarm will only project when a button is pressed. The projection will auto-focus for display from three to six feet away. The Projection Alarm can be set to project the time (M0), remote temperature (M1), or alternating between time and remote temperature (M2) by pressing and releasing the "DISPL" button. The selected display mode will flash on the lower middle as "M0", "M1" or "M2". The direction of the display can also be rotated 360° in 90° increments by pressing the directional button. The projector case can be rotated 180° to further help orient the projected display. Display Mode Light intensity Display Direction 7. The intensity of the projection can be adjusted to three different settings as well as turned "off" by pressing the light Intensity button. When turned off, the projection will only come on when a button is pressed. The intensity cannot be set for the projected display when set to "off". When only batteries are used, the intensity setting is set to "off" with no other options. 10 D. [. . . ] "--. -" appears in outdoor temperature LCD Problem: 1) Check batteries in remote Solution: 2) If batteries are replaced in remote, the unit must be re-started. "OFL" appears in the outdoor temperature LCD Problem: 1) Remote temperature is out of range. 3) Interference from an outside source (cordless telephone, etc. ) 4) Contact La Crosse Technology. Note: For any questions not answered, contact La Crosse Technology with the contact information found at the end of this instructional manual. [. . . ]