User manual KYOSHO V-ONE RRR WC TEAM EDITION EXPLODED VIEW

[. . . ] For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable. Statement of The Canadian Department of Communications Radio Interference Regulations This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada. EC Council Directive 73/23/EEC and 93/68/EEC of 22 July 1993 This product, has been designed and manufactured in accordance with the International Standards EN 60950, following the provisions of the Low Voltage Directive of the European Communities as of July 1993. [. . . ] We recommend that you unplug the printer from the power outlet whenever you do not plan to use it for long periods. Because of this, you should locate the printer so that the power outlet it is plugged into is nearby and easy to access. 1 POWER lamp (Green LED) Lights when the power is ON 2 ERROR lamp (Red LED) Indicates various errors in combination with POWER lamp 3 FEED button Press the FEED button to feed roll 3 FEED button paper. 5 second intervals On ERROR lamp Off On Recovery Conditions Automatically recovered after the print head has cooled. 5 second intervals Flashes at 1 second intervals ERROR lamp On Flashes at 0. 5 second intervals Flashes at 1 second intervals Recovery Conditions This is not a recoverable error. Note 1) If a non recoverable error occurs, turn the power OFF immediately. 2) When Power supply error occurs, there is a possibility that the power supply unit has a trouble. 125 second intervals Recovery Conditions Recovered If the cutter returns to the home position after turning the power OFF and ON. Restoration is also possible with the <DLE><ENQ>n command when in the ESC/POS mode. Note 1) If the cutter doesn't return to the home position, or doesn't perform the initial movement, it cannot be recovered. In particular, paper containing [Na+, K+, C1-] may drastically reduce the working life of the thermal head. Do not operate the printer if there is moisture on the front surface of the head from condensation, etc. Use the following procedure to adjust the near-end sensor so it is compatible with the size of roll paper you are using. 2 Determine the diameter of the roll paper you are using and find the required setting in the table below. 3 Insert the tip of a ballpoint pen or similar object into the hole of the adjuster, and then push and side the adjuster to the desired setting. When changing the setting, make sure that the position of the hole is aligned with the alignment mark indicated by the arrow. Adjustment value according to the paper you are using eNGLISH Paper thickness (µm) When using the paper roll with a core whose inside diameter (A):ø12, outside diameter (B):ø18 Detected diameter (C) Remained paper length (Approx. Note 1) The standard model is set to level 1 prior to being shipped from the factory. 2) The C dimension and the remained paper length are the calculated values. 3) As looseness will occur with the paper, leading to an increase in discrepancies between the C dimensions and remaining paper length, when the paper being used has a printer thickness of 85 µm, it is recommended that Level 2 is used. Pressing or pulling the paper during ejection may cause a paper jam, paper cutting failure or line feed failure. [. . . ] Be careful about installing the printer in an area where there is noise. Take the appropriate measures to protect against electrostatic AC line noise, etc. (1)MCBF (2) Cutter life 60 million lines (based on an average printing rate of 12. 5 million cuttings (if the paper thickness is between 65 and 85 µm) Two DIP switches are provided at the bottom of the printer, and can be set as given in the table below. [. . . ]