User manual KYOSHO SUNSTORM 600

[. . . ] *Hereby, KYOSHO CORPORATION, declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. :This symbol indicates where caution is essential to avoid injury to yourself or others. [. . . ] Also, disconnect and remove batteries from the model and the transmitter as batteries may overheat or leak causing damage. Always attach and close hatch when running, or damage from flooding may result. Do not store this model in a high-temperature/humidity area or in direct sunlight. Never put the charger and Ni-Cd battery near flam- able material m while charging as this may cause fires!Shorted circuits from batteries can cause fire so do NOT dissassemble or modify Ni-Cd batteries under any circumstances. For operating the Sunstorm 600, use only the Transmitter included with this product. Before switching power ON always rest boat on the stand and make sure propeller is clear should it spin. Place boat on stand, ensure propeller is clear, then check model is working properly. ' --§ Place boat on stand, ensure propeller is clear, then check model is working properly. Leave Throttle Trigger in neutral, then adjust Throttle Trim until propeller comes to a complete stop. Adjust the steering trim until the boat moves forward in a straight line. Do NOT allow the transmitter batteries to go "dead" or all model control will be lost. [. . . ] £ During set-up, if the set-up button is not pushed within 4~5 seconds, the ESC program mode will quit automatically without saving any data. B --p , « , ð ^á There is not enough charge left in Transmitter batteries. [. . . ]