User manual KYOSHO STRATUS 1600

[. . . ] Before commencing assembly, please read these instructions thoroughly. Oe First-time builders should seek the advice of experienced modellers before commencing assembly and if they do not fully understand any part of the construction. [. . . ] Use a sharp hobby knife and cut carefully to keep the gel-coat from peeling. , í , ¹ OES SJ, ¯ , é , ð Drill two holes in alignment with both holes in the motor. B Apply epoxy glue to only one side of the wing joiner and center wing. B Do NOT under any circumstances cut the antenna-wire as this will reduce range and possibly cause the plane to crash!Erratic flight and/or crashes can result if it comes loose during flight. B Adjust the travel of each control surface to the values in the diagrams. B , ð ` , Do not fly before confirming the correct location of the CG. If the CG is incorrect, you lose control of your airplane which leads to accidents!Oe First-time fliers should seek advice for hints in pre-flight adjustments and assembly from experienced fliers. Be reminded that flying a badly assembled or badly adjusted aircraft is very dangerous! [. . . ] With some electronic speed controllers, the electric motor (propeller) start spinning as soon as the electronic speed controller is connected. B ^ If your airplane does not function correctly, land it at once and find out the reason. [. . . ]