User manual KYOSHO OXALYS 50

[. . . ] ` , , µ , Ä Read through the manual before you begin, so you will have an overall idea of what to do. If you find any defective or missing parts, contact your local dealer or our Kyosho Distributor. [. . . ] B " " , ð Temporarily install the engine and make a hole for the throttle rod by aligning with the position of the throttle lever. B < Slide heat shrink tubes over linkage rods and use a shrink covering heat gun or similar to secure (shrink) them in place. B S , ð File down with the hole on an angle so the rods move smoothly. B , Make certain parts are aligned accurately and play is reduced to a minimum. B , Í , Å Adjust the travel of each control surface to the values in the diagrams. B , É In order to obtain the CG specified, reposition the receiver and other equipment. If the CG is incorrect, you lose control of your airplane which leads to accidents!*This aircraft has been flight tested with snap-rolls and other aerobatic maneuvers. *Repeated flying can cause stress cracks to appear in the wood and joints. If any abnormalities are noted, repair immediately before the next flight to avoid accidents. If you notice irregular flight, investigate the cause and repair it before the next flight. *As for linkages, inpropely assembling then can result in binding or loose control surfaces. [. . . ] B , ð , è , É Draw out the remaining fuel from the fuel tank and fill it back into the can. B , , è ñ S , ð Proper maintenance extends the life of your airplane. [. . . ]