User manual KYOSHO NITRO BLIZZARD

[. . . ] Oe Always keep this instruction manual ready at hand for quick reference, even after completing the assembly. E If already included with the radio, no battery box needs to be purchased separately. [. . . ] If both are not parallel, the backlash of the lower and upper gear will be either too tight or too loose, resulting in damages for the engine and transmission unit !B , , É "] Adjust the clutch bell and 2 speed transmission to rotate smoothly without any noise. Switch on the radio and make sure both gaps If not equal, correct with the throttle trim. Adjust the strength of brake (in other words, equalize the brake strength of both right and left) with 57 and 82 . B Before painting, use a neutral detergent to remove any oil residues and dirt. [ "à Paint the body shell from the inside using KyoshoÕs spray colors. B , Ì " " For reasons of safety, do not perform adjustments while the engine is running!For adjust-ing the engine, run the engine with the 3 x 3mm set screw tightened to make sure the engine does not shift up. Adjust the gear shift timing to your engine and the track with the 3 x 3mm set screw. As you tighten the 3 x 3mm set screw, the shift timing becomes slow, and as you unscrew it, the shift timing becomes quick. Adjust the timing by unscrewing the 3 x 3mm set screw by half turns actually while running the car. Set the timing so the gears shift up when 80% of total rpm are reached. [. . . ] WARNING: In order to avoid accidents and personal injury, be sure to observe the following: Never use fuel indoors or in places with open fires and sources of heat!Store fuel only in cool, dry and dark places out of children's reach! [. . . ]