User manual KYOSHO MINI-Z MR02 RM

[. . . ] Always turn power switch OFF and remove batteries when removing the body. Do not operate the model on public roads, in crowded places and near children. Do not run your car in sandy, dusty, wet conditions, or on thick/soft carpet. Do not use water, alcohol, or thinner to clean your car's body. [. . . ] The motor wiring is fitted with a circuit breaker that cuts power to the motor when heavy loads or damage to the motor causes excessive electrical current flow. Once the circuit breaker has been tripped, retrieve the model, turn the power off and remove all batteries. After about 5 minutes, the circuit breaker automatically resets and model can be operated again. Possible reasons for the circuit breaker tripping repeatedly are outlined below. Be sure to rectify the cause of the problem before operating the model. The model is being forced against an obstacle and cannot move forward Solution Stop applying the throttle and return it to neutral. If this still doesn't resolve the problem, the motor may be damaged or worn out. Gear ratio is not set correctly Solution This can occur if the gear ratio is too high-geared for the space available to run the model. If the model is operating at high temperatures or has been run continuously for some time, the circuit breaker trips more easily. Confirm body and wheelbase compatibility by referring to 'Suspension Shaft Position' on 5 Data Table from the MINI-Z Overland's Optional Parts List that can be downloaded from . When Throttle Trigger is in neutral and the car hasn't stopped moving, follow the steps below to adjust neutral position. With steering wheel in neutral, click the Steering Trim a few times so car runs in a straight line. When steering trim is in neutral or adjustment has reached the end of its range, beeping sound will start. Due to effects from steering mechanism or surface, the car may not run perfectly straight. You can adjust the steering angle (the degree to which tires turn) to your liking. Steering angle is less Steering angle is more Turn steering wheel all the way to the right (and hold). Be careful not to run the transmitter battery level too low or empty as controls will be lost. B Continue to hold Throttle Trim B down and confirm the LED lights up after 3 seconds. If chassis speed is too fast, speed can be adjusted to run slower for easier control. Raise the tires off the ground and check that all controls are responding. [. . . ] Raise the tires off the ground and check that all controls are responding. If you are unsure of the steering, practice holding the transmitter with the steering wheel facing you. Be careful not to squeeze the throttle trigger abruptly while steering. After you become familiar with the controls, practice with high speeds and high speed turns to experience the full potential of the machine. [. . . ]