User manual KYOSHO F4U CORSAIR M24

[. . . ] Oe Always keep this instruction manual ready at hand for quick · This model will require a minimum 4 channel radio control (with 5 standard servos) for aircraft, if having fixed undercarriage, or 5 channel radio (with 6 standard servos), if fitting retractable undercarriage. L Read instruction manual supplied with radio control system thoroughly before use. ê , Å For retract gear you will, you will need 5channel radio, 1 retract servo, 1 extension cord. [. . . ] ` , , µ , Ä Read through the manual before you begin, so you will have an overall idea of what to do. If you find any defective or missing parts, contact your local dealer or our Kyosho Distributor. ` Symbols used throughout this instruction manual comprise the following : @ not overlook this Do · , é Use an iron covered with a cloth, Start at low setting. Secure aileron hinges with instant glue, being careful not to glue the wing and aileron together. If coming off during flights, you lose control of your aircraft which leads to accidents!If coming off during flights, you lose control of your airplane which leads to accidents!B , If coming off during flights, you lose control of your airplane which leads to accidents!Non-observance of this information could lead to serious injury and/or damage to property. B , µ Only fly model aeroplanes in areas away from houses and places where people gather. Always regulate the engine from behind, but never from infront or from the sides, because a rotating propeller might badly injure you. B Do not fly your aeroplane if it is a windy day or there are strong cross winds. Do not allow watching people to get too close to a rotating propeller. B If the model begins to operate by itself, there is another transmitter operating on your frequency. Do not try to operate your model if this happens, but change your transmitter and receiver crystals to another frequency. [. . . ] Do not try to operate your model if this happens, but change your transmitter and receiver crystals to another frequency. B By moving the various transmitter controls, ensure that all control surfaces move the way you intend them to. B To start the engine, set low throttle on the transmitter and hold the engine starter against the spinner. [. . . ]