User manual KYOSHO EVOLVA 2005

[. . . ] B As the front end of the antenna may be dangerous, do not aim it toward faces. B Do not store this model in a high-temperature/humidity area or in direct sunlight. WARNING: Do NOT operate the model in the following places and situations: (Non-observance may lead to accidents! [. . . ] You may lose control of your model when operating it under such condition. Keep in mind that people around you may also operate a radio control model!WARNING: In order to avoid accidents and personal injury, be sure to observe the following: VORSICHT: Zur Unfall- und Sachschadenvermeidung, beachten Sie bitte auch folgendes: ATTENTION: Respectez les consignes suivantes afin de faire voluer votre mod le en toute s curit : AVISO: Lea los siguientes consejos para prevenir posibles accidentes. Never use fuel indoors or in places with open fires and sources of heat!Store fuel only in cool, dry and dark places out of children's reach!B , ª Adjusts the throttle in small increments so the model will not move at neutral. B , Ì Control the speed of the model and movement forward and backward. B , ª Adjusts the steering in small increments so the model will run straight. B , Í --p Transmitters other than the one included cannot be used with this product. B , ¦ "® Cool engine down, then slightly loosen the needle valve and re-start engine. If you fail to break-in an engine, the lubricating oil inside does not circulate and the engine will be caked with burns; running becomes difficult and engine life is shortened. [ C " " As the engine is set intentionally to run at low RPM when it is shipped from the factory, the car will not shift into 2nd gear. Before adjusting the timing of the gear change, be sure the run the engine in and adjust the engine properly. K , Ì , ª When the throttle control is in neutral, the car does not speed off even!B I ^ , È Pointeau The needle valve setting for normal engine running lies between 2 turns unscrew Aguja from closed position. Start the engine as explained in the chapter < Way of Starting Engine > and run your car. B ^Ê'u Watch the speed of your car running down a straight with the throttle control moved to high. When screwing in the needle valve 10¡~20¡, speed increases. [. . . ] When your car's speed reaches the peak, the needle valve setting is optimal. B ^Ê'u < When screwing the needle valve further in, exhausts become in-visible and rpm decrease. Note that for normal running, the needle valve is screwed out 10¡~20¡ from the valve's optimal setting position! [. . . ]