User manual KYOSHO EP JET F22 RAPTOR EXPLODED VIEW

[. . . ] aLL printer installations require Physical Setup and Local Printer Installation. Before you begin, be sure that all the items listed below are included in your package. Keep your packing materials and carton in case you ever need to ship or transport the unit. If you have a ML390/1T network printer, you can use the applicable ML390/1T Users Manuals and Network Documentation that is included on the CD. [. . . ] The documentation, printer drivers, and network information are provided on the CD-ROM included with the printer. Your printer has a parallel port, a USB (Universal Serial Bus) port, and a network interface (if your printer has a network card). The steps you use to install your printer vary according to your · Two versions are available: a single-bin and a dual bin. The Menu Groups you will see when working with the menu depend on which version of the option you install with your printer. The difference between a printer with a USB port and a printer without a USB port is the location of the CSF connector. Printers with the USB port have a CSF connector on the top, back, left-hand corner of the printer. Printers without the USB port have a CSF connector on the back of the printer. The documentation for your printer is provided as a combination of on-line documentation on the CD and hardcopy documentation provided with the printer. The CSF (Cut Sheet Feeder) connector has been moved to the top, back, left-hand corner of the printer. The settings listed below are the changes or additions to those listed in the User's Guide. The factory default setting for the Top of Form (where the printing should begin) is one inch down from the top of the page. Your software may print the first line of print above or below where TOF is set. use the procedures in the Printer User's Guide , "Using Your Printer , Top of Form , Forms Tear-Off Status (ON or OFF). " The first line prints at the red line of the plastic paper shield (1) on the printhead. How you set the Top of Form depends on the status of the Forms Tear-Off menu setting. To load single sheets, see your Printer User's Guide, "Installation, Paper Loading. " To load bottom-feed paper, see the instructions provided with the pull/push tractors. Wide Carriage Models Microline 321 Turbo/n, Microline 391 Turbo/n If you are using 8. 5 inch paper to run the test, make sure the paper width selection in the printer menu is set to 8. Run the Font Sample Test to make sure your printer is operating properly. [. . . ] Run the Font Sample Test to make sure your printer is operating properly. to run the test: · Turn the printer off, then press and hold the LF key while turning the printer back on. Some countries may require a different adapter for local voltages, such as 240 VAC. Use the Add Printer wizard, not the menu installer, to install 64-bit drivers: 1. [. . . ]