User manual KYOSHO EP BLUESTREAK 800

[. . . ] Before commencing assembly, please read these instructions thoroughly! OeFirst-time builders should seek the advice of experienced modellers before commencing Assembly and if they do not fully understand any part of the construction. [. . . ] B ­Ê , Glued surface should be free from any oil residues and dirt. B , Tighten the 3x12 TP Screws and make sure the easy movement of rudder to the directions as arrows show. B , Ì , Ì The decal numbers between brackets are only for the opposite side. "x X Adjusting the running posture and the speed by adjusting the angle of propeller. ¨ 'á , ¢ Wind : light Waves : low · , µ Do not adjust the rudder beyond this point. B , K , Ì OE¯ , Ì , ð In order to avoid accidents and personal injury, be sure to observe the following: With R/C boats, discover a new world of pleasure. Wheth- r you run your boat on lakes, rivers or elsee where, take precautionary measures to avoid accidents. B Do not put your hands or any objects into rotating parts, as this could result in serious accidents!B For accident prevention, do not run your model under the following circumstances: · B in places where many people gather!, µ , « , ê , « when rivers are swollen or their current is strong!B , ª , « Also make sure that nobody is using the same frequency as you do at the same time!B Never put the charger and Ni-Cd battery near flam-mable material while charging as this may cause fires! [. . . ] Should servo cords and the receiver antenna be damaged, return them to the manufacturer for repair. Should speed controller not return to neutral, readjust linkages as per instruction manual. [. . . ]