User manual KYOSHO DMT

[. . . ] Any liability for passive damages or damage of any kind occurred due to data loss incurred by a defect of the product, repair performed by the third party other than Olympus or an Olympus authorized service station, or any other reasons is excluded from the Olympus' liability. If the product is used without observing the information given under this symbol, minor personal injury, damage to the equipment, or loss of valuable data may result. To protect the high-precision technology contained in this product, never leave the recorder in the places listed below, no matter if in use or storage: · Places where temperatures and/or humidity are high or go through extreme changes. Direct sunlight, beaches, locked cars, or near other heat sources (stove, radiator, etc. [. . . ] Keep this manual in an easily accessible location for future reference. To protect yourself and others from personal injury or damage to property, it is essential that you always read the warnings and information provided. Stop using the recorder immediately if you notice any unusual odors, noise, or smoke around it. Never remove the batteries with bare hands, which may cause a fire or burn your hands. Handle the recorder with care to avoid getting a low-temperature burn. When the recorder contains metal parts, overheating can result in a low-temperature burn. pay attention to the following: · When used for a long period, the recorder will get hot. If you hold on to the recorder in this state, a low-temperature burn may be caused. In places subject to extremely cold temperatures, the temperature of the recorder's body may be lower than the environmental temperature. If possible, wear gloves when handling the recorder in cold temperatures. To prevent causing battery leaks or damaging their terminals, carefully follow all instructions regarding the use of batteries. Recording from external microphones or other devices: External microphones and other devices can be connected and the sound can be recorded. Do not plug and unplug devices into the recorder's jack while it is recording. The built-in microphone will become inoperable when an external microphone is plugged into the recorder's MIC jack. " · To avoid ear irritation, insert the earphone after turning down the volume level. When you listen with the earphone during playback, do not raise the volume too much. While the recorder is during playback mode, press and hold the 9 or 0 button. While the recorder is during stop mode or playback mode, press the 9 button. If the recorder is in the middle of a file, it will return to the beginning of the file. 2 Press the `OK button again to open the playback speed adjustment display. While the recorder is during recording mode, pressing the DISPLAY button will make the display switch information in the following order: 1 If you leave the recorder for 3 seconds, the setting will be applied and the recorder will return back to the original screen. " · Even if playback is stopped, the changed playback speed will be retained. [. . . ] It varies greatly according to the type of batteries used and the conditions of use. It is prohibited to record copyrighted material without permission of the copyright holders according to copyright law. Specifications and design are subject to change without notice for improvement of performance. "CE" mark indicates that this product complies with the European requirements for safety, health, environment and customer protection. [. . . ]