User manual KYOCERA TASKALFA 820

[. . . ] TASKalfa 620/820 OPERATION GUIDE Please read this Operation Guide before using this machine. Keep it close to the machine for easy reference. This Operation Guide is for models TASKalfa620 and TASKalfa820. In this guide, TASKalfa620 refers to the 62 cpm (copies per minute) model and TASKalfa820 to the 82 cpm model. NOTE: This Operation Guide contains information that corresponds to using both the inch and metric versions of these copiers. [. . . ] In addition, if originals have punched holes or perforations, load them with the holes or perforations away from the leading edge. · · · · Transparencies for overhead projectors Delicate originals such as carbon paper, crumpled paper, or vinyl sheets Irregularly shaped (non-rectangular) originals, wet originals, or originals containing adhesive tape or glue Originals bound with clips or staples. (To avoid jams, remove the clips or staples and straighten any curls, wrinkles, or creases before loading them. Failure to do so may cause the originals to jam. ) Originals with cut-out sections or with very slippery surfaces Originals with correction fluid which is not dried Originals with folds. Failure to do so may cause the originals to jam. ) · · · How to Load Originals Follow these steps to load originals in the document processor. IMPORTANT: Before loading originals, be sure there are no originals left on the original eject table. Originals left on the original eject table may cause the new originals to jam. 2-16 Preparing to Copy 1 Adjust the original width guides to fit the originals. 2 Place the originals. Put the side to be copied (or the first side of two-sided originals) face-up. Slide the leading edge into the document processor as far as it will go. IMPORTANT: Confirm that the original width guides exactly fit the originals. Pull out the ejection guide for originals of 8 1/2 × 14" (B4) or 11 × 17" (A3). Ensure that loaded originals do not exceed the level indicated. Exceeding the maximum level may cause the originals to jam. Original placement indicator The original placement indicator is lit or unlit depending on how originals are placed. PIndications and their status are as follows. · · · Green (left indicator) lit : Original is placed properly. Remove the jammed original and place it properly. 2-17 Preparing to Copy Loading Originals on the Platen To copy books, magazines, or other originals that cannot be loaded in the document processor, open the document processor and place the original directly on the platen. Adjust how the document processor opens by using the document processor angle adjustment lever. Move the lever left to open the document processor 60° and move it right to open the document processor 30°. IMPORTANT: Before opening the document processor, be sure that there are no originals left on the original table or on the original eject table. Originals left on the original table or on the original eject table may fall off the copier when the document processor is opened. Do not move the document processor angle adjustment lever when the document processor is open. Close the document processor before using the lever. 1 Open the document processor. 2 Place the original. Put the copying side facedown and align it flush against the original size indicator plates with the back left corner as the reference point. Inch models 2-18 Preparing to Copy Metric models 3 Close the document processor. For originals over 4 cm thick, leave the document processor open during copying. IMPORTANT: Do not push the document processor forcefully when you close it. [. . . ] Take sufficient care when working in this area, as there is a danger of electrical shock. Caution The fixing unit is extremely hot. Take sufficient care when working in this area, as there is a danger of getting burned. 6 Remove the paper from above the paper conveyor. 7 Open the cover A4. 8 Remove the jammed paper. If the paper tears, remove any loose scraps from the copier. 6-19 Troubleshooting 9 10 Close the cover A4. [. . . ]