User manual KYOCERA KM-4230

[. . . ] INSTRUCTION HANDBOOK Please read the instruction handbook before using the copier. Keep it close to the copier for easy reference. As an ENERGY STAR Partner, KYOCERA MITA CORPORATION has determined that this product meets the ENERGY STAR guidelines for energy efficiency. The ENERGY STAR program is an energy reduction plan introduced by the United States Environmental Protection Agency in response to environmental issues and for the purpose of advancing the development and utilization of more energy efficient office equipment. registered mark. The Auto-Shut-off time setting becomes 15 to 120 minutes in the areas corresponding to the Swiss Energy 2000 program. <Attention> This instruction handbook is for the KM-4230 (42 ppm) and KM-5230 (52 ppm). [. . . ] Press the energy saver key to perform copying. 48 APPLICABLE COPY MODES (1) Reserving another copy while copying is performed [Add Job] While copying is performed, another copying can be reserved. * When this copy mode is used, the optional memory copy board is required. q Introduction of the add job screen 1 Job number key: The serial number is assigned until 99 in the order of registration. Even when the order is altered and the job is cleared, no number is changed. Copying operation is carried out from the job displayed in the upper part. 5 Residual memory: The data volume of originals stored in memory is displayed. * The form overlay mode cannot be used in the add job function. 1 Add job 1. If the message "ADDITION OF JOB IS POSSIBLE. " is displayed, the job can be reserved. * To stop job reservation, touch the "END" or "BACK" key. 2. Referring to page 19 and subsequent pages, set the function to be reserved and press the Start key. After all the original has been read, the touch panel will return to the step 2 screen. Copying will begin in the order of reservation when the copying of previously reserved job is completed. 49 APPLICABLE COPY MODES 2 Changing the setting contents of the add job The setting of finishing for the reserved job (number of copies and sorter mode) can be changed. When changing the number of copies, touch the "+" key or "-" key for setting. * Change the setting of finishing. * If an optional finisher has been installed, the staple sort mode and the punch mode can be adjusted. When using the booklet stitcher, the staple sort mode can be adjusted. 5. After all the settings has been completed, touch the "END" key. The touch panel will return to the basic screen. 50 APPLICABLE COPY MODES 3 Clearing the add job 1. The touch panel will return to the basic screen. 4 Changing the add job order Although job will be copied in the order of reservation, the order can be changed after the reservation. Change the order by touching the "v UP" key or "w DOWN" key. * Copying operation is carried out from job displayed upper side to lower. 51 APPLICABLE COPY MODES 4. The touch panel will return to the basic screen. (2) Copying various originals at a time [Job build function] Job build functions enable to read the originals separately in several times and copy them at a time. The originals of the large number or different types can be copied at a time by reading those of the same size or the same type as one job and storing each job. 9 modes can be selected depending on the type of originals or the finishing copying mode. [. . . ] Unscrew the two reversing cover screws d located on the left side of the duplex unit. Close the reversing cover and fix it with the 2 reversing cover screws. * If the paper does tear, remove any scraps of torn paper from inside the copier. Close the front cover. 102 ABOUT 52 PPM COPIER q Specifications Specifications described on page 98 are different as follows. [. . . ]